Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

8DVMRPBrocade# show ip dvmrp routeP:Parent M:MetricTotal Routes=1SourceNet Mask Gateway P M153.1.0.0 255.255.0.0 * v153 1Int v153 phy_p e1/36 nbr 153.1.1.2 age=0 NOT downstreamshow ip dvmrp trafficSyntax: show ip dvmrp trafficThis command displays active multicast traffic information, as shown in the following example.Brocade# show ip dvmrp trafficPort Probe Graft Prune[Rx Tx Dscrd] [Rx Tx Dscrd] [Rx Tx Dscrd]e5/2 111 112 0 0 0 0 9 0 1e8/1 0 220 0 0 0 0 0 0 0v10 0 211 0 0 0 0 0 0 0v20 0 210 0 0 0 0 0 0 0Total 111 1718 0 0 0 0 9 0 1IGMP Statistics:Total Discard/chksum 0/0DVMRP debug commandsThis section describes the debug commands used for monitoring the DVMRP environment.debug ip pim-dvmrpSyntax: [no] debug ip pim-dvmrp [add-del-oif | bootstrap | clear | event | group | ipc | join-prune| level | nbr-change | route-change | show | source | vlan-id | vpls-id]• add-del-oif - Displays multicast cache (mcache) additions or deletions.• bootstrap - Displays bootstrap messages in detail.• clear - Clears PIM-DVMRP debug settings.• event - Displays information about infrastructure events and callback handling.• group - Displays activity for a specific group.• ipc - Displays information about IPC messages between the management processor and a lineprocessor.• join-prune - Displays information about join or prune messages.• level - Sets the level of debug information from 1 through 3 (3 generates the most detailedinformation).• nbr-change - Displays information about neighbor port changes.• route-change - Displays information about route change events.• show - Shows PIM-DVMRP debug settings.• source - Displays information about multicast traffic from a specific source.• vlan-id - Displays information about a specified VLAN.• vpls-id - Displays information about a specific VPLS ID.272 Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide53-1002426-02