Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

7ACLsshow access-list accounting briefSyntax: show access-list accounting brief [l2 | policy-based-routing | rate-limit]• l2 - Limits the display to Layer 2 ACL accounting information.• policy-based-routing - Limits the display to policy-based routing accounting information.• rate-limit - Limits the display to rate limiting ACL accounting information.If no option is specified, IPv4 ACL accounting statistics are displayed.To display a brief summary of the number of hits in all ACLs on a device, enter the followingcommand.Brocade# show access-list accounting briefCollecting ACL accounting summary for VE 1 ... Completed successfully.ACL Accounting Summary: (ac = accumulated since accounting started)Int In ACL Total In Hit Out ACL Total Out HitVE 1 111 473963(1s)25540391(1m)87014178(5m)112554569(ac)show access-list accountingSyntax: show access-list accounting [ethernet / | pos/ | ve ] [in | out] [l2 | policy-based-routing | rate-limit]• ethernet / - Displays a report for an Ethernet interface.• pos / - Displays a report for a POS port.• ve - Displays a report for the ports that are included in a virtual routing interface.For example, if ports 1/2, 1/4, and 1/6 are all members of ve 2, the report includesinformation for all three ports.• in - Displays statistics for incoming traffic.• out - Displays statistics for outgoing traffic.• l2 - Limits the display to Layer 2 ACL accounting information.• policy-based-routing - Limits the display to policy-based routing accounting information. Thisoption is only available for incoming traffic.• rate-limit - Limits the display to rate limiting ACL accounting information.This command displays statistics for an interface, as shown in the following example.Brocade# show access-list accounting ve 1 inCollecting ACL accounting for VE 1 ... Completed successfully.ACL Accounting Information:Inbound: ACL 1111: deny tcp any anyHit count: (1 sec) 237000 (1 min)12502822(5 min) 87014178 (accum) 995170003: permit ip any anyHit count: (1 sec) 236961 (1 min) 13037569(5 min) 0 (accum) 130375690: deny tcp 1.1.1.0 0.0.0.255 2.2.2.0 0.0.0.255Hit count: (1 sec) 0 (1 min) 0(5 min) 0 (accum) 02: deny udp any anyHit count: (1 sec) 0 (1 min) 0(5 min) 0 (accum) 0244 Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide53-1002426-02