Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

MPLS API 6debug mplsSyntax: [no] debug mplsThis command is used to turn on the debugging output, while preserving the debuggingconfiguration.Brocade# debug mplsBrocade# show debugMPLS Debug SettingsMPLS Debug is ONForwardingAlldebug mpls allSyntax: [no] debug mpls allThis command is used to turn on debugging for all MPLS configurations.debug mpls errorSyntax: [no] debug mpls errorThis command is used to turn on error debugging for all the modules.Brocade# debug mpls errorBrocade# show debugMPLS Debug SettingsMPLS Debug is OFFErrorAllMPLS clear commandUse the following clear command to clear MPLS counter information.clear mpls debug countersSyntax: clear mpls debug counters [aall | ai3 | amb | ambl | amh | ase | asel | bfd | i3 | ipl | ipr| nbase-root | ntl | rcp | rcs | rldf | rlm | rri | rric | rrt | rsip | rspx | rstc | sck | yads]This command clears the debug counters.NOTEThe show mpls debug counter and clear mpls debug counters commands are hidden CLIcommands.MPLS APIThe Multiprotocol Label Switching (MPLS) Application Programming Interface (API) is the MPLSinterface to applications, such as L2VPN (for VLL and VPLS), BGP, IPSTATIC, IS-IS, OSPF, and PBR.The applications must register for the events with the MPLS when they need to use the MPLStunnels. The MPLS API generates events when the tunnels and pseudowires are established andreleased, and sends the events only to the applications that have been registered.Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide 19553-1002426-02