12.07.2015 Views

Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

MPLS 6TTL 255, TOS 0, NHT 1, MTU 1476show mpls forwardingSyntax: show mpls forwarding [ | in-label ]• - Displays MPLS forwarding information for a specific IP address.• in-label - Displays MPLS forwarding information for a specific incoming label.This comm<strong>and</strong> displays MPLS forwarding information, as shown in the following example.<strong>Brocade</strong># show mpls forwardingTotal number of MPLS forwarding entries: 1Dest-prefix In-lbl In-intf Out-lbl Out-intf Sig Next-hop1 140.140.140.4/32 1024 ve10 R 10.10.10.2show mpls lspSyntax: show mpls lsp [[up | down] [detail] | name ]• up - Displays information about the operationally up LSPs.• down - Displays information about the operationally down LSPs.• detail - Displays detailed information about the LSP.• name - Displays LSP information for the specified LSP name.This comm<strong>and</strong> displays information about a Label Switched Path (LSP), as shown in the followingexample.<strong>Brocade</strong># show mpls lsp up detailLSP to_DUT2, to 2.2.2.2From: 1.1.1.1, admin: UP, status: UP, tunnel interface(primary path): tnl0Times primary LSP goes up since enabled: 1Metric: 0, number of installed aliases: 0Maximum retries: 0, no. of retries: 0Pri. path: to2, up: yes, active: yesSetup priority: 7, hold priority: 0Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytesConstraint-based routing enabled: yesTie breaking: r<strong>and</strong>om, hop limit: 0LDP tunneling enabled: noActive Path attributes:Tunnel interface: tnl0, outbound interface: e1/1Tunnel index: 1, Tunnel instance: 1 outbound label: 3Path calculated using constraint-based routing: yesPath calculated using interface constraint: noExplicit path hop count: 110.10.10.2 (S)Recorded routes:Protection codes: P: Local N: Node B: B<strong>and</strong>width I: InUse10.10.10.2Fast Reroute: facility backup desiredBackup LSP: UP, out-label: 3, outbound interface: e1/4 bypass_lsp: b1FRR Forwarding State: Pri(active), Backup(up)show mpls lsp nameSyntax: show mpls lsp name The name parameter specifies the name of the LSP for which you want to displayinformation.<strong>Brocade</strong> <strong>MLX</strong> <strong>Series</strong> <strong>and</strong> <strong>Brocade</strong> <strong>NetIron</strong> <strong>XMR</strong> <strong>Diagnostic</strong> <strong>Guide</strong> 19153-1002426-02

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!