Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

MPLS DiagnosticsChapter6This chapter contains diagnostic information for the MPLS configurations.MPLSMultiprotocol Label Switching (MPLS) debug and show commands help the users to diagnose anddetermine the cause of faults for MPLS-related features.The following sections describe show and debug commands that can be used to obtain informationabout MPLS activity.MPLS show commandsThis section describes the show commands that display MPLS information.show mpls bypass-lspSyntax: show mpls bypass-lsp [detail]This command displays detailed information about the MPLS bypass LSP, as shown in the followingexample.Brocade# show mpls bypass-lsp detailLSP b1, to 2.2.2.2From: 1.1.1.1, admin: UP, status: UP, tunnel interface(primary path): tnl1Times primary LSP goes up since enabled: 1Metric: 0, number of installed aliases: 0Maximum retries: 0, no. of retries: 0Pri. path: NONE, up: yes, active: yesSetup priority: 7, hold priority: 0Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytesConstraint-based routing enabled: yesTie breaking: random, hop limit: 0LDP tunneling enabled: noActive Path attributes:Tunnel interface: tnl1, outbound interface: e1/4Tunnel index: 2, Tunnel instance: 1 outbound label: 3Path calculated using constraint-based routing: yesPath calculated using interface constraint: noRecorded routes:Protection codes: P: Local N: Node B: Bandwidth I: InUse30.30.30.1exclude interface(s): e1/1Tunnel bandwidthMaximum BW: 0 kbpsReservable BW [priority] kbps:[0] 0 [1] 0 [2] 0 [3] 0[4] 0 [5] 0 [6] 0 [7] 0Riding ingress backup lsps: 1Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide 18553-1002426-02