Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

Generic debug commands 1show debugSyntax: show debugThe show debug command displays all enabled debug functions. Command output resembles thefollowing example, which shows that RSTP and IS-IS debugging are enabled, with the console asthe output destination.Brocade# show debugRSTPRSTP: debugging is onDebug message destination: ConsoleINTEGRATED IS-IS :IS-IS: isis debugging is on INTEGRATED IS-IS :IS-IS: isis debugging is ondebug allSyntax: [no] debug allThis command enables all debug functions, and must only be used during troubleshooting. Tocancel this setting, enter the no debug all command.Brocade# debug allWarning! This may severely impact network performance!All possible debuggings have been turned onCAUTIONThis command generates extensive output and can significantly slow device operation. Use thiscommand with caution. Never use this command during periods of peak network activity. Enterno debug all to stop the output.NOTEYou may not be able to see the no debug all command as you type it. However, if you have typed thecommand correctly, output will stop as soon as you press the Enter key.debug destinationSyntax: [no] debug destination [console | logging | telnet | ssh ]This command allows you to specify a destination for debugging output. The default is the systemconsole, but you can redirect output to a syslog buffer, or a Telnet or SSH session. The followingparameters are available for this command:• console - Directs output to the system console.• logging - Directs output to the syslog buffer and to the syslog server (default).• telnet - Directs debugging output to a specified Telnet session (a number from 1through 5).• ssh - Directs debugging output to a specified SSH session (a number from 1 through5).Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide 353-1002426-02