Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

IS-IS 5show isis debug v6route-infoSyntax: show isis debug v6route-infoThis command displays the routes in the IS-IS IPv6 route table. For each route, it displays the nexthops, the cost from the root node, flags, and its parent path entries, as shown in the followingexample.Brocade# show isis debug v6route-infoISIS IPv6 Routing TableTotal Routes: 1 Level1: 0 Level2: 1 Equal-cost multi-path: 1Type IPv6 Prefix Next Hop Router Interface CostL2 5000:2000::/64 fe80::202:17ff:fe6e:c41c eth 1/11 0PENT:Cisco.00-00 cost:10, Pre:2, Up/Down:0 flags:Act Ena IPv6show ip route isisSyntax: show ip route isisThis command displays information about IS-IS routes, as shown in the following example.Brocade# show ip route isisType Codes - B:BGP D:Connected I:ISIS S:Static R:RIP O:OSPF; Cost - Dist/MetricDestination Gateway Port Cost Type1 30.30.30.0/24 50.50.50.10 gre_tnl 1 115/20 IL12 100.100.100.0/24 50.50.50.10 gre_tnl 1 115/20 IL13 100.100.101.0/24 50.50.50.10 gre_tnl 1 115/20 IL14 100.100.102.0/24 50.50.50.10 gre_tnl 1 115/20 IL15 100.100.103.0/24 50.50.50.10 gre_tnl 1 115/20 IL16 100.100.104.0/24 50.50.50.10 gre_tnl 1 115/20 IL17 100.100.105.0/24 50.50.50.10 gre_tnl 1 115/20 IL18 100.100.106.0/24 50.50.50.10 gre_tnl 1 115/20 IL19 100.100.107.0/24 50.50.50.10 gre_tnl 1 115/20 IL1show isis hostnameSyntax: show isis hostnameThis command displays IS-IS name mappings, as shown in the following example.Brocade# show isis hostnameTotal number of entries in IS-IS Hostname Table: 1System ID Hostname * = local IS* bbbb.cccc.dddd IMRIS-IS debug commandsThis section describes the debug commands used for monitoring the IS-IS environment.debug isisSyntax: [no] debug isis [adj | bfd | error | interface | l1-csnp | l1-hello | l1-lsp | l1-psnp | l2-csnp| l2-hello | l2-lsp | l2-psnp | lsp-flood | lsp-dump | memory | nsr | pp-hello | ppp | pspf |pspf-detail | redistribution | route-table | spf | spf-log | te | trace]• adj - Displays information about IS-IS adjacencies.• bdf - Displays IS-IS BFD information.• error - Displays IS-IS errors.• interface - Limits the display of IS-IS information to a specific interface.Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide 16753-1002426-02