Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

5IS-IS200.1.5.0/24 3 0 1 1100.1.2.0/24 3 0 1 1100.1.5.0/24 3 0 1 1200.1.8.0/24 3 0 1 1100.1.8.0/24 3 0 1 1100.1.11.0/24 3 0 1 1200.1.3.0/24 3 0 1 1100.1.3.0/24 3 0 1 1200.1.6.0/24 3 0 1 1200.1.9.0/24 3 0 1 1100.1.6.0/24 3 0 1 1100.1.9.0/24 3 0 1 1100.1.1.0/24 3 0 1 1200.1.4.0/24 3 0 1 1200.1.7.0/24 3 0 1 1100.1.4.0/24 3 0 1 1100.1.7.0/24 3 0 1 1200.1.10.0/24 3 0 1 1show isis debug route-infoSyntax: show isis debug route-info [ | ]• | - Specifies the IP network address.This command displays the routes in the IS-IS route table. For each route, it displays the next hops,the cost from the root node, flags, and its parent path entries, as shown in the following example.Brocade# show isis debug route-info 10.0.0.1/3210.0.0.1 255.255.255.255 30 L2 00000000 00000008 000Path: 1 Next Hop IP: 192.168.1.125 Interface: 4/16Route 3741d938Level-1 Info List is emptyLevel-2 Info ListPENT-V4:AR1.00-00 cost:10, Pre:2, Up/Down:0 flags:Act Ena IPv4show isis debug summarySyntax: show isis debug summaryThis command displays summary information about redistributed routes, such as whether a routeis active (UP=yes or no), the metric (cost), the level (L column), and so on.Brocade# show isis debug summarySummary UP Met L100.1.0.0 /16 Y 1 3 (e1=11,e2=11,i1=0,i2=0) (l1=12e0fc34/1 l2=12e0fb14/1)show isis debug v6-nexthopsSyntax: show isis debug v6-nexthopsThis command displays information about IS-IS IPv6 next hops, as shown in the following example.Brocade# show isis debug v6-nexthopsIS-IS IPv6 Nexthops List:IS-IS IPv6 Null0 Nexthops List:Node 2185b000 -> Nexthop 2809f000 ref 0, If 65534(drop) Addr ::IS-IS IPv6 Nexthops Set List:166 Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide53-1002426-02