Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide ...

1Generic debug commandsSep 27 18:06:57:I:Interface ethernet3/2, state upSep 27 15:39:42:I:Interface ethernet3/2, state upSep 27 15:39:42:I:Interface ethernet6/2, state upSep 27 14:23:45:N:Module up in slot 6Sep 27 14:23:45:N:Module up in slot 3Sep 27 14:23:27:A:Management module at slot 9 state changed from standby to activeGeneric debug commandsThe following generic debug commands perform functions related to all debugging actions:• debug ? - Generates a list of debug options.• [no] debug all - Enables or disables all debug functions.• show debug - Shows all enabled debug settings.• debug destination - Allows you to select an output destination: Telnet, SSH, console, or logging(default).debug ?Syntax: debug ?The debug ? command generates a list of available debug variables.ATTENTIONMany first-level variables have their own variable subsets. When you enter a debug command, thesystem will indicate that there are additional variables by telling you that you have entered anincomplete command. Add a space and a question mark to your original command to view theadditional variables.Brocade# debug ipIncomplete command.Brocade# debug ip?access-listallbfddestinationdot1xfiltersgvrpipipv6isismac..Enable ACL debuggingEnable all debuggingEnable BFD debuggingRedirect debug messageDebug 802.1X and EventsEnable Filters debuggingEnable gvrp debuggingDebug trace IPDebug trace IPv6Debug isisEnable MAC database debugging2 Brocade MLX Series and Brocade NetIron XMR Diagnostic Guide53-1002426-02