English - Service après vente - Dewalt

ENGLISHd) Remove any adjusting key or wrenchbefore turning the power tool on. Awrench or a key left attached to a rotatingpart of the power tool may result in personalinjury.e) Do not overreach. Keep properfooting and balance at all times. Thisenables better control of the power tool inunexpected situations.f) Dress properly. Do not wear looseclothing or jewellery. Keep your hair,clothing and gloves away from movingparts. Loose clothes, jewellery or long haircan be caught in moving parts.g) If devices are provided for the connectionof dust extraction and collection facilities,ensure these are connected and properlyused. Use of dust collection can reducedust-related hazards.4) POWER TOOL USE AND CAREa) Do not force the power tool. Use thecorrect power tool for your application.The correct power tool will do the jobbetter and safer at the rate for which itwas designed.b) Do not use the power tool if the switchdoes not turn it on and off. Any powertool that cannot be controlled with the switchis dangerous and must be repaired.c) Disconnect the plug from the powersource and/or the battery pack fromthe power tool before making anyadjustments, changing accessories, orstoring power tools. Such preventive safetymeasures reduce the risk of starting thepower tool accidentally.d) Store idle power tools out of the reachof children and do not allow personsunfamiliar with the power tool or theseinstructions to operate the power tool.Power tools are dangerous in the hands ofuntrained users.e) Maintain power tools. Check formisalignment or binding of moving parts,breakage of parts and any other conditionthat may affect the power tool’s operation.If damaged, have the power tool repairedbefore use. Many accidents are caused bypoorly maintained power tools.f) Keep cutting tools sharp and clean.Properly maintained cutting tools with sharpcutting edges are less likely to bind and areeasier to control.g) Use the power tool, accessories andtool bits etc., in accordance with theseinstructions taking into account theworking conditions and the work tobe performed. Use of the power tool foroperations different from those intendedcould result in a hazardous situation.5) SERVICEa) Have your power tool serviced by aqualified repair person using only identicalreplacement parts. This will ensure that thesafety of the power tool is maintained.ADDITIONAL SPECIFIC SAFETY RULESSafety Instructions for All Operationsa) This power tool is intended to functionas a grinder, sander, wire brush, polisheror cut-off tool. Read all safety warnings,instructions, illustrations and specificationsprovided with this power tool. Failure to followall instructions listed below may result in electricshock, fire and/or serious injury.b) Do not use accessories which are notspecifically designed and recommendedby the tool manufacturer. Just because theaccessory can be attached to your power tool,it does not assure safe operation.c) The rated speed of the accessory must be atleast equal to the maximum speed markedon the power tool. Accessories running fasterthan their rated speed can break and fly apart.d) The outside diameter and the thickness ofyour accessory must be within the capacityrating of your power tool. Incorrectly sizedaccessories cannon be adequately guarded orcontrolled.e) The arbour size of wheels, flanges, backingpads or any other accessory must properlyfit the spindle of the power tool. Accessorieswith arbour holes that do not match themounting hardware of the power tool will runout of balance, vibrate excessively and maycause loss of control.f) Do not use a damaged accessory. Beforeeach use inspect the accessory such asabrasive wheel for chips and cracks, backingpad for cracks, tear or excess wear, wirebrush for loose or cracked wires. If powertool or accessory is dropped, inspect fordamage or install an undamaged accessory.After inspecting and installing an accessory,position yourself and bystanders away fromthe plane of the rotating accessory and runthe power tool at maximum no-load speedfor one minute. Damaged accessories willnormally break apart during this test time.7