1004D3 and 1005E3 API Bottom Loading Coupler - The Meter and ...

API Bottom Loading Coupler1004D3/1005E3Step 3• Connect the coupler to the adapter. Slide the sleeve fullyforward. Fully rotate the operating handle and in the openposition, the operating handle cam surface should prevent thesleeve from sliding back.MAINTENANCEConsider the following when servicing thecoupler:• When coupler is over pressurized, it must beinspected thoroughly.• After maintenance is performed, it must betested before the next use (see couplerTesting).• Periodical inspection (every 3 months) forleakages (especially with toxic or hazardousmediums).DISASSEMBLYINSTRUCTIONSStep 1: Dismantle API couplerAttention: Dismantling must be performed byauthorized and trained personnel only.Attention: The same risks and procedures ofinitial installation apply.• Maintenance must be performed by authorized personnel.• Periodical maintenance (once a year) is required according tothe maintenance instructions.• When any leakages are found, have seals replaced immediatelyto obtain a safe and correct use of the coupler. If leakagescontinue contact the OPW distributor or the OPW EngineeredSystems for consultation.Warning: Make sure what kind of medium has been or is beingloaded with this coupler, reading the manuals provided with thecoupler. When the medium is unclear, hazardous or toxic, one isobligated to clean the parts with the help of specialized personnel,companies or governments.Before dismantling coupler make some necessary preparationsFigure A• Securefrommovementthe devicethe coupleris attachedto (FigureA)Figure B• Make sure to use adequate personalprotection at all times during the operation.• Clear surrounding areas and shut off anyworking devices.• Make sure the surrounding area is clear fromobstacles.• Barricade surrounding area, so nounauthorized persons can access work floor.• Arrange necessary permits or paperwork withplant holder, owners or local authorities, beforetaking any actions.When the coupler is clean and dry and the necessary preparations have been made, the coupler can bedisassembled from the device it is attached to.PHONE: (800) 547-9393 • (513) 696-1500 • Fax: (800) 245-8536 • (513) 932-9845Printed in USA2726 Henkle Drive • Lebanon, OH 45036 • www.opw-es.com © Copyright 2009, OPW Engineered Systems