DWFXTM Installation Guide.qxd - Actionair

More documents

Recommendations

Info

DWFX TM Installation Guide12 Cut the vertical (side) edges of the holeThe vertical sides of the hole may now be cut.13 Remove the cut material to leave the holeThe waste wall material should now be removed. Trying toremove some of the board layers first, rather than trying toremove the slug as a whole may ease this.14 Tidy up all the edges of the holeTidy up all the edges of the hole to leave in as flat and clean astate as possible, so that it can be easily lined with fresh boardmaterial4 www.actionair.co.uk
DWFX TM Installation Guide15 Frame out top and bottom edges of the holeCut some track of the same type and dimension as that whichwas used in the wall construction. This should be slightly longerthan the hole top and bottom edge dimension (up to 25mmlonger). One piece is required for the bottom and one for the topof the hole. This track should be carefully be pushed in to gap toface of the cavity. It may be necessary to V-notch the ends of thetrack to be able to force it in at the ends.16 Frame out the sides of the holeCut some stud of the same type and dimension as that whichwas used in the wall construction. This should be the same asthe hole side edge dimension. One piece is required for eachside. This stud should be carefully be pushed in to gap to face ofthe cavity.www.actionair.co.uk5
Page 1 and 2: December 2006DWFX TM Installation G
Page 3: DWFX TM Installation Guide1 General
Page 7 and 8: DWFX TM Installation Guide20 Drill
Page 9 and 10: DWFX TM Installation Guidewww.actio

DWFXTM Installation Guide.qxd - Actionair

Create successful ePaper yourself

Delete template?

Save as template?