GENERAL CATALOGUE - Urmet

TELEPHONE INTERFACESDoor phone/telephone interfacesThis device is used to allow communication, also at the same time, with a dial lineand a loudspeaking unit using a single telephone and allowing to open the door.With a cordless phone, you can take incoming calls from anywhere in your home,e.g. from the garden, the balcony or the loft.Specifically, the new door phone interface 1332/40 offers various installation solutions: direct powerfrom loudspeaking unit, management of two door units, door unit call confirmation tone, etc.1332/401072/671332/40 Door phone/telephone interfaceInterface device for telephone lines and door phone systems and replacesthe 1332/30. One device connected to an analogue dial line and 4+n door phonesystem (this device must be connected to other dedicated interfaces).Allows to manage telephone and door phone calls to a single telephone terminal.Set up for connecting to two loudspeaking units and equipped with two relaysfor opening the door or for auxiliary services. Supplies power (+6Vdc) to a PE anddifferent operating modes, programmable directly from the connected phone.Power: 12 Vac. Minimum consumption: 3/10VA. Installation: DIN bar.Dimensions: 108 (W) x 90 (H) x 55 (D) mm (6 DIN modules).1072/67 Bibus PABX interface. Wall-mounted installationFor using Scaitel Agorà PABX in Bibus systems and maintaining the originalfunctions (door phone call and conversation, concierge switchboard calland conversation, door opening, special services, floor call).1038/67 Digivoice/4+n voice adapterWall-mounted installation. Consumption: 2.5 mA. For using Agorà Urmetswitchboards in an apartment. Manages “4+n” audio output and may be connectedto telephone switchboard or used in a mixed Digivoice and “4+n” system.955/67 PABX interface for “1+1” audio and 5-wire video systemsThe device is used to connect a Scaitel PABX switchboard to a 5 wire videoor “1+1” audio system and to manage all services connected to the audio/videosystem: calls, conversations between telephone and loudspeaking unit, dooropening. Dimensions: 125 (W) x 100 (H) x 40 (D) mm. Input voltage: > 2.5Vac.Voltage during operation: 5.9V @ 25 mA.1082/67 2GO! interface. Installation on 6 DIN module barConnected to 2GO! riser column (by means of one-user distributor Ref. 1082/51to be purchased separately) supplies typical 4+n signal outputs (1 - 2 - CA - 6 - 9)for connecting to any PABX. Video signal output on coax base band to terminalsV3-V5 for connecting any non-coax 4+n brackets. This allows the followingsolutions: connection of Utopia speaker with 1703/91 bracket and 1703/2 monitor;connection of one or two monitors with coax bracket in apartment, while in 2GO!system the apartment is seen as a single device; PABX with telephonesand video modules; connection to a relay 788/1 and a one-family kit with coaxfor floor calls by video loudspeaking unit.Dimensions: 108 (W) x 90 (H) x 61 (D) mm.1083/67 2Voice-PSTN interface and videoThis device allows to connect an analogical telephone or a telephone interface ora PABX to a 2Voice system, to be able of using interphone services also througha telephone terminal. The video is supplied on a coax-type output for connectionof compatible terminals.This interface can be programmed in two modes: “internal place” or “call forwarding”as an aid to the 1083/40 gatekeeper lodge exchange.- Power supply: 110/230Vac with power supply provided with kit- Size: 10 DIN modules- Size of Power Supply: 1.5 DIN modulesTELEPHONY• 149