2005 MY OBD System Operation Summary for Gasoline Engines

More documents

Recommendations

Info

Note: BARO is inferred at engine startup using the KOEO MAP sensor reading. It is updated during high, partthrottle,high rpm engine operation.EGR Flow Check Operation:DTCsMonitor executionMonitor SequenceSensors OKMonitoring DurationP0400once per driving cycleNoneCPS, ECT, IAT, MAF, MAP (P0106/7/8), TP, BARO not available yet15 seconds to register a malfunction (assumes 4 samples)Typical EGR flow check entry conditions:Entry Condition Minimum MaximumDesired EGR Mass Flow> 0 lb/minEngine RPM 1450 rpm 2700 rpmInferred Ambient Air Temperature 20 o F 140 o FEngine Coolant Temperature164 o FRelative Throttle Position 0.09 volts 0.6 voltsEngine Load 42 % 63 %Vehicle Speed 47 mph 56 mphEngine RPM Steady (change/0.050 sec)Throttle Position Steady (change/0.050 sec)50 rpm0.024 voltsEngine Load Steady (change/0.050 sec) 1.5 %BAROO2 sensor tests not running: amplitude test, openloopdownstream forced-excursion testNo accessory state changes:22.5 "HgNeutral/Drive,A/C On/Off,Low Speed Fan On/Off,Power Steering On/Off,High Speed Fan On/OffTypical EGR flow check malfunction thresholds:Sum of MAP-delta and IMAP delta < 0.62 " Hg orSum of MAP-delta and IMAP delta > 8.00 " Hg orEGR-On MAP > BARO – 0FORD MOTOR COMPANY REVISION DATE: APRIL 28, 2004 PAGE 62 OF 131
J1979 Mode $06 DataTest ID Comp ID Description for J1850 Units$4E $31 Sum of MAP-delta and IMAP delta and max. threshold in Hg$4E $31 Sum of MAP-delta and IMAP delta and min. threshold in Hg$4F $00 EGR-On MAP and max threshold in HgConversion for Test ID 4E and 4F: Take value and multiply result by 0.0078125 to get inches of Hg. Theresult is always positive.Monitor ID Test ID Description for CAN Units$33 $80 Sum of MAP-delta and IMAP delta, min and max thresholds kPa$33 $81 EGR-On MAP and max threshold kPaI/M Readiness IndicationIf the inferred ambient temperature is less than 20 o F, greater than 130 o F, or the altitude is greater than 8,000 feet(BARO < 22.5 "Hg), the EGR flow test cannot be reliably done. In these conditions, the EGR flow test issuspended and a timer starts to accumulate the time in these conditions. If the vehicle leaves these extremeconditions, the timer starts decrementing, and, if conditions permit, will attempt to complete the EGR flow monitor.If the timer reaches 500 seconds, the EGR flow test is disabled for the remainder of the current driving cycle andthe EGR Monitor I/M Readiness bit will be set to a “ready” condition after one such driving cycle. Starting in the2002 MY, vehicles will require two such driving cycles for the EGR Monitor I/M Readiness bit to be set to a "ready"condition.FORD MOTOR COMPANY REVISION DATE: APRIL 28, 2004 PAGE 63 OF 131
Page 1:
Table of ContentsIntroduction - OBD
Page 4 and 5:
!The Catalyst Efficiency Monitor us
Page 6 and 7:
TYPICAL INDEX RATIO CATALYST MONITO
Page 8 and 9:
There are three different misfire m
Page 10 and 11:
0#1The acceleration that a piston u
Page 12 and 13: J1979 Misfire Mode $06 DataTest ID
Page 14 and 15: 0$Secondary air systems typically u
Page 16 and 17: 201 34536/#/Vehicles that meet enha
Page 18 and 19: 0.040” EVAP Monitor Operation:DTC
Page 20 and 21: 201 3536/#/Some vehicles that meet
Page 22 and 23: slosh. If the monitor aborts, it wi
Page 24 and 25: 0.020” EVAP Monitor Operation:DTC
Page 26 and 27: Test ID Comp ID Description for J18
Page 28 and 29: Ford's EONV implementation for Cali
Page 30 and 31: 1#4;!In this phase, the EONV test i
Page 32 and 33: 0.020” EONV EVAP Monitor Operatio
Page 34 and 35: 201!!#/Additional malfunctions that
Page 36 and 37: Fuel Tank Pressures Sensor Offset C
Page 38 and 39: :As fuel system components age or o
Page 40 and 41: -:-The time between HO2S switches i
Page 42 and 43: $-A functional test of the rear HO2
Page 44 and 45: -- 3 amps, (NTK)< 0.400 amps or > 3
Page 46 and 47: 1:$The Delta Pressure Feedback EGR
Page 48 and 49: If an EGR system malfunction is det
Page 50 and 51: After the vehicle has warmed up and
Page 52 and 53: 1:$In the 2002.5 MY, Ford introduce
Page 54 and 55: The ESM may provide the PCM with a
Page 56 and 57: Next, the differential pressure ind
Page 58 and 59: I/M Readiness IndicationIf the infe
Page 60 and 61: The Stepper Motor EGR Monitor consi
Page 64 and 65: $. 6The Electric Stepper Motor EGR
Page 66 and 67: The MAP sensor is also checked for
Page 68 and 69: When the entry conditions for the f
Page 70 and 71: 1!2Ford plans to comply with the PC
Page 72 and 73: ETC System Failure Mode and Effects
Page 74 and 75: ;#11!%;11!)The purpose of the TPPC
Page 76 and 77: Currently, vehicles use either an E
Page 78 and 79: Fuel Rail Pressure Sensor Check Ope
Page 80 and 81: Loss of Keep Alive Memory (KAM) pow
Page 82 and 83: CKP Ignition System Check Operation
Page 84 and 85: The Idle Air Control (IAC) solenoid
Page 86 and 87: There are several different styles
Page 88 and 89: The PCM continually calculates a ca
Page 90 and 91: Most vehicle applications no longer
Page 92 and 93: Intermediate Shaft Speed Sensor Fun
Page 94 and 95: Primary Pulley Speed Sensor Functio
Page 96 and 97: Secondary Pulley Pressure Sensor Ch
Page 98 and 99: Typical Shift Solenoid mechanical f
Page 100 and 101: Shift Completion Check Operation:DT
Page 102 and 103: Pressure Control Solenoid Check Ope
Page 104 and 105: Forward Clutch/Reverse Clutch Solen
Page 106 and 107: 4$=%$> );4R70E is the replacement f
Page 108 and 109: ! 4%:> );;The Analog Transmission R
Page 110 and 111: $%$> );;The Digital Transmission Ra
Page 112 and 113:
Direct One Way ClutchThe Direct One
Page 114 and 115:
Direct One Way ClutchThe Direct One
Page 116 and 117:
$&&> %$> );;Transmission Range Sens
Page 118 and 119:
4:=%:.)%:> );;The Transmission Rang
Page 120 and 121:
CFT 30 Mechatronic Illustration;Tra
Page 122 and 123:
Internal TCM Power SupplyIf the pow
Page 124 and 125:
shift, rpm does not go up during a
Page 126 and 127:
The shift solenoids are monitored f
Page 128 and 129:
*> #606Exponentially Weighted Movin
Page 130 and 131:
@$!The readiness function is implem
show all

2005 MY OBD System Operation Summary for Gasoline Engines

Create successful ePaper yourself

Delete template?

Save as template?