Bosch Rexroth IndraDyn S - MKE Project Planning Manual

78/131 Bosch Rexroth AG | Electric Drivesand ControlsRexroth MKE Synchronous Motors | Project Planning ManualOperating Conditions and Application NotesOther environmental influencesMotor-internal holding brake (if applicable)the risk of an effect into the danger zone is reduced. (ATEX Directive 94/9/EG,Appendix II, section 1.6.2)The user has the following possibilities:●●Energy isolation is guaranteed from the exit of the drive device, if at emergencystop, in addition to the power loss, the drive device is lockedelectronically. This is done by switching off the power contactor - withsubsequent failure reaction of the drive device because of power failure(cp. F281). Adjusting the required drive-end failure reaction must be madeby the user at the drive device via the drive parameters (cp. P-0-0119)according to the functional description.To have the encoder feeder cable also de-energized, shut down the controlvoltage of the drive device.After the control voltage and the power of the drive device are interrupted, theexit on the motor side has electronically locked itself over the output stage andeventually stored energies in the intermediate direct current link are therewithisolated on the motor side and on the output side.●The intermediate direct current link short-circuit can be used – if possible– to reduce the energies within the intermediate direct current link of thedrive device after shutdown of supply voltage fast.Irrespective of these possibilities, the user has to check – as stipulated in thenotes regarding safety - by means of an appropriate measuring instrument, ingeneral, before working on the machine, if the machine or parts of it are underresidual voltage (e.g. caused by rest energy of condensers in filters and drivedevices etc.). Wait for their discharging time.Heed the following regarding dangers caused by other disturbances:●●●Operation only inside the specified ambient conditions,Do not exceed the maximum vibration and shock loads.Prevent corrosion due to humidity, aggressive substances and soiling ofthe protective conductor connections.see chapter 9.11 "Holding Brakes (Ex)" on page 90 .9.1.3 Type Test of the Motors according to European Standard (EN)MKE motor are manufactured according to the European standards●EN 50014: 1992 and● EN50018: 20001994 and are controlled by the Physikalisch Technischen Bundesanstalt PTB.Motor type Licence No. Ignition protection types /protection concepts orstandardsMKE037/047/098 PTB 03 ATEX 1107 X Pressure-resistant casingMKE118PTB 03 ATEX 1108 Xd/ acc. To EN 50014 andEN 50018Conformity certificateFig.9-4:Type tests MKE motorsDeclarations of conformity confirming the structure and the compliance with theapplicable EN standards are available for all MKE motors. The conformity certificatesare included in the scope of supply of the motor and are attached tothis documentation.