Bosch Rexroth IndraDyn S - MKE Project Planning Manual

68/131 Bosch Rexroth AG | Electric Drivesand ControlsRexroth MKE Synchronous Motors | Project Planning ManualConnection Techniqueon the motor flange). Protective conductor cross-section see fig. 8-2 " Additionalprotective conductor" on page 66.8.3 Connection according to American Standard (UL)Power and encoder connectionFig.8-5:Connection overview according to American standardThe connection of the MKE motors, according to American standard, consistsof the following components:●●●a power connector, incl. connection for temperature sensor and holdingbrake, single-wire constructionencoder connection, standard-cable constructionadditional outside connection for an equipotential bonding conductor (accordingto EN 50014: 1992)The connection cable of the MKE motors are to be realised through a specialcable duct into the motor. The ca. 1.5 m long connection cables have to be ledthrough a ¾ inch metal pipe into an approved Ex terminal box (see fig. 8-1 "Connection variants MKE motors" on page 65). Standard connection cableslead from an Ex terminal box to a drive control device.