Bosch Rexroth IndraDyn S - MKE Project Planning Manual

Project Planning Manual | Rexroth MKE Synchronous Motors Electric Drivesand Controls| Bosch Rexroth AG 21/131Safety Instructions for Electric Drives and Controls3.3.6 Protection During Handling and MountingCAUTIONRisk of injury by improper handling! Injury by crushing, shearing, cutting,hitting!●●●●●●●●Observe the relevant statutory regulations of accident prevention.Use suitable equipment for mounting and transport.Avoid jamming and crushing by appropriate measures.Always use suitable tools. Use special tools if specified.Use lifting equipment and tools in the correct manner.Use suitable protective equipment (hard hat, safety goggles, safety shoes,safety gloves, for example).Do not stand under hanging loads.Immediately clean up any spilled liquids from the floor due to the risk ofslipping.3.3.7 Battery SafetyBatteries consist of active chemicals in a solid housing. Therefore, improperhandling can cause injury or property damage.CAUTIONRisk of injury by improper handling!●●●●●●Do not attempt to reactivate low batteries by heating or other methods (riskof explosion and cauterization).Do not attempt to recharge the batteries as this may cause leakage orexplosion.Do not throw batteries into open flames.Do not dismantle batteries.When replacing the battery/batteries, do not damage the electrical partsinstalled in the devices.Only use the battery types specified for the product.Environmental protection and disposal! The batteries contained inthe product are considered dangerous goods during land, air, andsea transport (risk of explosion) in the sense of the legal regulations.Dispose of used batteries separately from other waste. Observe thenational regulations of your country.3.3.8 Protection Against Pressurized SystemsAccording to the information given in the Project Planning Manuals, motors andcomponents cooled with liquids and compressed air can be partially suppliedwith externally fed, pressurized media, such as compressed air, hydraulics oil,cooling liquids and cooling lubricants. Improper handling of the connected supplysystems, supply lines or connections can cause injuries or property damage.