NEXO NXAMP 4X1 Owner's Manual - Yamaha Commercial Audio

XLR-type connectors are wired as follows (IEC60268 standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-).Use only Neutrik NL4 plugs for connecting Speakon connectors.NEXO-SA cannot be held responsible for damage caused by improper use or modifications to the device or data that is lost or destroyed.• Always turn the power off when the device is not in use.• The performance of components with moving contacts, such as switches, volume controls, and connectors, deteriorates over time. Consult qualified NEXO-SA servicepersonnel about replacing defective components.• If you do not intend to rack-mount the NXAMP, attach the included rubber feet to the bottom surface of the device.IMPORTANT NOTICE FOR THE UNITED KINGDOMConnecting the Plug and CordWARNING: THIS APPARATUS MUST BE EARTHEDIMPORTANT. The wires in this mains lead are colored in accordance with the followingcode:GREEN-AND-YELLOW: EARTHBLUE : NEUTRALBROWN : LIVEAs the colors of the wires in the mains lead of this apparatus may not correspondwith the colored markings identifying the terminals in your plug proceed as follows:The wire which is colored GREEN-and-YELLOW must be connected to the terminal inthe plug which is marked by the letter E or by the safety earth symbol or coloredGREEN or GREEN-and-YELLOW.The wire which is colored BLUE must be connected to the terminal which is markedwith the letter N or colored BLACK.The wire which is colored BROWN must be connected to the terminal which is markedwith the letter L or colored RED.• This applies only to products distributed in the United Kingdom.COMPLIANCE INFORMATION STATEMENT (DECLARATION OF CONFORMITY PROCEDURE)1) This device may not cause harmful interference, and2) This device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference toradio reception is suspected.* This applies only to products distributed in the United States of America.EUROPEAN MODELSPurchaser/User Information specified in EN55103-1 and EN55103-2.Inrush Current: 16 AConforms to Environments: E1, E2, E3 and E4.This mark indicates a dangerous electrically live terminal. When connecting an external wire to this terminal, it is necessary either tohave a “a person who have received appropriate guidance on handling” make the connection or to use leads or a cord that have beenmanufactured in such way that the connection can be made simply and without problem.