NEXO NXAMP 4X1 Owner's Manual - Yamaha Commercial Audio

QUICK START(7) Rear end mounting holesBasic functionsIf the NXAMP is to be rack mounted and transported frequently, be sure to support therear end of the unit with mounting hardware that matches the size of the rack used.ResetYou can reset the unit without powering off by simultaneously depressing buttons A, B &“Select CH1” for 3 seconds at least.Selecting cabinet family(for 3 seconds)Simultaneously depressing A & B buttons at power up or during device RESET accesses thesystem change menu. Keep the A & B Buttons held until all LEDs are off (approx. 20seconds). This will allow the selection of any cabinet in any family. Using the rotaryencoder, scroll through the configurations and press “B” to load the required settings.Select your cabinet set-upIn the ‘Options’ menu, choose “Systm Config”, and you will be able to choose among thedifferent set-ups within the same cabinet family. (i.e. you don't have to modify theamplifier to cabinet wiring).PAGE 16 OF 80