2000 Cadillac Catera Owners Manual

PUSHBUTTONS: The six numbered pushbuttons letyou return to your favorite stations. You can set up to18 stations (six AM, six FM1 and six FM2). Just:1. Turn the radio on.2. Press BAND to select AM, FM1 or FM2.3. Tune in the desired station.4. Press and hold one of the six numbered buttonsfor more than two seconds until you hear a beep.Whenever you press that numbered button for lessthan two seconds, the station you set will return.5. Repeat the steps for each pushbutton.When battery power is removed and later applied, youwill not have to reset your radio presets because theradio remembers them.PRESET SCAN: Press and hold SCAN for two tothree seconds until PRESET SCAN appears on thedisplay to listen to each of your preset stations fora few seconds (factory presets which have not beenreprogrammed with your stations will be ignored).The radio will go to the first preset station stored onyour pushbuttons, stop for a few seconds, then go onto the next preset station. Press SCAN again to stopscanning. If a preset station has weak reception,the radio will not stop at the preset station.Setting the ToneBASS: Press this knob lightly so it extends. Turn theknob clockwise to increase and counterclockwise todecrease bass.TREB: Press this knob lightly so it extends. Turn theknob clockwise to increase and counterclockwise todecrease treble. If a station is weak or noisy, you maywant to decrease the treble.Push these knobs back into their stored positions whenyou’re not using them.Adjusting the SpeakersBAL: Press this knob lightly so it extends. Turn theknob clockwise to adjust sound to the right speakersand counterclockwise for the left speakers. The middleposition balances the sound between the speakers.FADE: Press this knob lightly so it extends. Turn theknob clockwise to adjust the sound to the front speakersand counterclockwise for the rear speakers. The middleposition balances the sound between the speakers.Push these knobs back into their stored positions whenyou’re not using them.3-10