2000 Cadillac Catera Owners Manual

2000 Cadillac Catera Owners Manual 2000 Cadillac Catera Owners Manual

wpc.3cdd.edgecastcdn.net
from wpc.3cdd.edgecastcdn.net More from this publisher
12.07.2015 Views

This light should come on, as a check to show you it isworking, when the ignition is on and the engine is notrunning. If the light doesn’t come on, have it repaired.This light will also come on during a malfunction in oneof two ways:Light Flashing -- A misfire condition has beendetected. A misfire increases vehicle emissions andmay damage the emission control system on yourvehicle. Dealer or qualified service center diagnosisand service may be required.Light On Steady -- An emission control systemmalfunction has been detected on your vehicle.Dealer or qualified service center diagnosis andservice may be required.If the Light Is FlashingThe following may prevent more serious damage toyour vehicle: Reducing vehicle speed. Avoiding hard accelerations. Avoiding steep uphill grades. If you are towing a trailer, reduce the amount ofcargo being hauled as soon as it is possible.If the light stops flashing and remains on steady, see“If the Light Is On Steady” following.If the light continues to flash, when it is safe to do so,stop the vehicle. Find a safe place to park your vehicle.Turn the key off, wait at least 10 seconds and restart theengine. If the light remains on steady, see “If the LightIs On Steady” following. If the light is still flashing,follow the previous steps, and drive the vehicle to yourdealer or qualified service center for service.If the Light Is On SteadyYou may be able to correct the emission systemmalfunction by considering the following:Did you recently put fuel into your vehicle?If so, reinstall the fuel cap, making sure to fully installthe cap. See “Filling Your Tank” in the Index. Thediagnostic system can determine if the fuel cap has beenleft off or improperly installed. A loose or missing fuelcap will allow fuel to evaporate into the atmosphere.A few driving trips with the cap properly installedshould turn the light off.Did you just drive through a deep puddle of water?If so, your electrical system may be wet. The conditionwill usually be corrected when the electrical systemdries out. A few driving trips should turn the light off.2-73

Are you low on fuel?As your engine starts to run out of fuel, your engine maynot run as efficiently as designed since small amounts ofair are sucked into the fuel line causing a misfire. Thesystem can detect this. Adding fuel should correct thiscondition. Make sure to install the fuel cap properly.See “Filling Your Tank” in the Index. It will take afew driving trips to turn the light off.Have you recently changed brands of fuel?If so, be sure to fuel your vehicle with quality fuel (see“Fuel” in the Index). Poor fuel quality will cause yourengine not to run as efficiently as designed. You maynotice this as stalling after start-up, stalling when you putthe vehicle into gear, misfiring, hesitation on accelerationor stumbling on acceleration. (These conditions may goaway once the engine is warmed up.) This will be detectedby the system and cause the light to turn on.If you experience one or more of these conditions,change the fuel brand you use. It will require at leastone full tank of the proper fuel to turn the light off.If none of the above steps have made the light turn off,have your dealer or qualified service center check thevehicle. Your dealer has the proper test equipment anddiagnostic tools to fix any mechanical or electricalproblems that may have developed.Emissions Inspection and Maintenance ProgramsSome state/provincial and local governments have ormay begin programs to inspect the emission controlequipment on your vehicle. Failure to pass thisinspection could prevent you from getting avehicle registration.Here are some things you need to know in order to helpyour vehicle pass an inspection:Your vehicle will not pass this inspection if theCHECK ENGINE light is on or not working properly.Your vehicle will not pass this inspection if theOBD (on-board diagnostic) system determinesthat critical emission control systems have not beencompletely diagnosed by the system. The vehicle wouldbe considered not ready for inspection. This can happenif you have recently replaced your battery or if yourbattery has run down. The diagnostic system is designedto evaluate critical emission control systems duringnormal driving. This may take several days of routinedriving. If you have done this and your vehicle stilldoes not pass the inspection for lack of OBD systemreadiness, see your dealer or qualified service centerto prepare the vehicle for inspection.2-74

This light should come on, as a check to show you it isworking, when the ignition is on and the engine is notrunning. If the light doesn’t come on, have it repaired.This light will also come on during a malfunction in oneof two ways:Light Flashing -- A misfire condition has beendetected. A misfire increases vehicle emissions andmay damage the emission control system on yourvehicle. Dealer or qualified service center diagnosisand service may be required.Light On Steady -- An emission control systemmalfunction has been detected on your vehicle.Dealer or qualified service center diagnosis andservice may be required.If the Light Is FlashingThe following may prevent more serious damage toyour vehicle: Reducing vehicle speed. Avoiding hard accelerations. Avoiding steep uphill grades. If you are towing a trailer, reduce the amount ofcargo being hauled as soon as it is possible.If the light stops flashing and remains on steady, see“If the Light Is On Steady” following.If the light continues to flash, when it is safe to do so,stop the vehicle. Find a safe place to park your vehicle.Turn the key off, wait at least 10 seconds and restart theengine. If the light remains on steady, see “If the LightIs On Steady” following. If the light is still flashing,follow the previous steps, and drive the vehicle to yourdealer or qualified service center for service.If the Light Is On SteadyYou may be able to correct the emission systemmalfunction by considering the following:Did you recently put fuel into your vehicle?If so, reinstall the fuel cap, making sure to fully installthe cap. See “Filling Your Tank” in the Index. Thediagnostic system can determine if the fuel cap has beenleft off or improperly installed. A loose or missing fuelcap will allow fuel to evaporate into the atmosphere.A few driving trips with the cap properly installedshould turn the light off.Did you just drive through a deep puddle of water?If so, your electrical system may be wet. The conditionwill usually be corrected when the electrical systemdries out. A few driving trips should turn the light off.2-73

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!