LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron

More documents

Recommendations

Info

Installing and Identifying PortsInstalling and Identifying PortsBefore configuring the software you will need to gather and document the correct port information. This informationwill be critical during the configuration process as you will need to instruct the software which specific port you areusing.If you are using a serial port connection, skip directly to the section Finding The Port Number on page 4. If yourcomputer does not have this type of port and only has USB capabilities, you will need to use a USB-to-RS232(“COM Port”) Converter (not supplied.) The details for how to configure it are listed in the following section Addinga USB-to-RS232 (“COM Port”) Converter on page 4.Adding a USB-to-RS232 (“COM Port”) ConverterPlease see the manufacturers instructions.Finding The Port NumberClick the lower-left Start button and select Control Panel. Depending on your windows configuration you may needto click Start, select Settings and then click Control Panel.• Double-click on the System icon.4
MR-GRID-II Installation & Activation Guide• Select the Hardware tab and click on the Device Manager button.Scroll down the list that appears to Ports and click on the small ‘+’ . The additional list that appears shows all theports on your PC. The one named USB Serial Port will be the one you just installed, with the COM# associated withit.5
Page 3: MR-GRID-II Installation GuideTable
Page 7: MR-GRID-II Installation & Activatio
Page 11 and 12: MR-GRID-II Installation & Activatio
Page 13 and 14: MR-GRID-II Installation & Activatio
Page 15: MR-GRID-II Installation & Activatio
Page 18 and 19: Printer Port InterfaceConfiguration
Page 20 and 21: Activation ProcedureActivation Proc
Page 22 and 23: Activation ProcedureGenerate an Act
Page 24 and 25: Activation ProcedureCompose an E-Ma
Page 28: © 2007 Secutron, Inc.No part of th

LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron

Create successful ePaper yourself

Delete template?

Save as template?