LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron

More documents

Recommendations

Info

Port 3 InterfaceSystem WatchNOTICE TO USERS, INSTALLERS, AUTHORITIES HAVING JURISDICTION, AND OTHER INVOLVED PARTIESThis product incorporates field-programmable software. In order for the product to comply with the requirements in theStandard for Control Units and Accessories for Fire Alarm Systems, UL 864, certain programming features or options mustbe limited to specific values or not used at all as indicated below.Program feature or option Permitted in UL 864? (Y/N) Possible Settings Settings permitted in UL 864To control the panel from theCADGraphics program No As below NoneThe System Watch program responds to incoming data from every fire alarm and security device onyour site, and immediately alerts your staff to alarms and malfunctions.You can customize yourSystem Watch screen to emphasize information that is important to you. A full description of how toconfigure System Watch is included in the CADgraphics manual located on the CD (D:\User's Guide).You will be able to find the shortcut in the CADgraphics folder within the Programs folder in your Startmenu.• Click Start.• Select Programs and move your mouse to the CADgraphics folder. There you will find theConfiguration Manager. Open the program.To be able to control the panel(s) from MR-GRID-II you will need to enable the Acknowledge, Resetand Silence buttons in the System Watch program.• Press the Setup button and enter the password (3 by default). Check the Acknowledge, SignalSilence and Reset buttons.The "Type a Password for Ack, Silence or Reset" box is checked by default; if you wish to have theoperators have use of the controls without using a password, uncheck this box.Be advised that it may take some time to configure the columns to suit your needs.In the System Watch setup under the List Options tab is the setting "Save Column Widths on Exit". Leave thisbox checked until you have the screens set up to suit your requirements. Once the screens are in this state uncheckthe box. Once you uncheck it, closing and restarting the program will reset the column (and other) settings.10
MR-GRID-II Installation & Activation GuidePrinter Port InterfaceNote: These instructions deal only with items specific to the Secutron interface. Please refer to theCADgraphics Users Guide for general setup and programming information.This supplied interface will connect to a printer port on the panel. This does not allow for control of the panel fromthe MR-GRID-II program; the panel will need to be attended to.There are no special requirements for MHI or the panel.For the MR-2100/2200 please refer to LT-2052 Printer Connection for MR-2100/2200 FACP for interconnectioninformation. For the MR-2900 refer to Diagram 3 below for wiring.YEL(PIN #5)BRN(PIN #2)RED(PIN #3)DIAGRAM 3TO COMPUTERCopy the files in the Panel Drivers/Printer Output directory on the CD into the CADgraphics directory on thecomputer.11
Page 3: MR-GRID-II Installation GuideTable
Page 7 and 8: MR-GRID-II Installation & Activatio
Page 13: MR-GRID-II Installation & Activatio
Page 18 and 19: Printer Port InterfaceConfiguration
Page 20 and 21: Activation ProcedureActivation Proc
Page 22 and 23: Activation ProcedureGenerate an Act
Page 24 and 25: Activation ProcedureCompose an E-Ma
Page 28: © 2007 Secutron, Inc.No part of th

LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron

Create successful ePaper yourself

Delete template?

Save as template?