LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron
LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron LT-2061 MR-GRID-II Installation Guide Rev0 112707 - Secutron
Port 3 InterfaceSetting Passwords and Communication SettingsDouble-click the CG-Secutron - Shortcut to start the new interface.• Choose Edit/Admin Passwords. For convenience, these should probably be set to the same as the rest of theprogram (3 by default), though different passwords can be used if so desired.• Select File/Open from the menu and choose the Modul-R-1.CSI file. Click Open.• Now choose Edit/Communications Settings and select 9600 baud, 8 data bits, parity none and 1 stop bit.Confirm that the channel is 1, enter the Port ID number that you documented during the process described inInstalling and Identifying Ports on page 4 and select OK.• Select Edit/Default CSI and choose Modul-R-1.CSI again.• Now choose File/Save.8
MR-GRID-II Installation & Activation GuideConfiguration ManagerNow open the Configuration Manager. You will be able to find the shortcut in the CADgraphics folder within thePrograms folder in your Start menu.• Click Start.• Select Programs and move your mouse to the CADgraphics folder. There you will find the ConfigurationManager. Open the program.• You will be prompted to enter a password. The default is password.• Click OK.• Choose Setup/System COM Ports.• Select the item listed in the Port Settings table as highlighted below. Until you do this you will not be ableto select the channel number or access the Channel App.• Set the System type to Custom - Single/Network.• Choose the correct COM port and set for 9600 baud, 8 data bits, no parity and 1 stop bit. Choose the baudrate to match the panel. Set the Channel to 1 and leave the Channel App blank.• Press Done.Note: Be sure to click the Setup button on the COM ports screen and verify that at least one node islisted that points to a MR-GRID-II-defined "System Panel." For further information refer to page 116of the CADgraphics Users Guide.9
- Page 3: MR-GRID-II Installation GuideTable
- Page 7 and 8: MR-GRID-II Installation & Activatio
- Page 9 and 10: MR-GRID-II Installation & Activatio
- Page 11: MR-GRID-II Installation & Activatio
- Page 15: MR-GRID-II Installation & Activatio
- Page 18 and 19: Printer Port InterfaceConfiguration
- Page 20 and 21: Activation ProcedureActivation Proc
- Page 22 and 23: Activation ProcedureGenerate an Act
- Page 24 and 25: Activation ProcedureCompose an E-Ma
- Page 28: © 2007 Secutron, Inc.No part of th
Port 3 InterfaceSetting Passwords and Communication SettingsDouble-click the CG-<strong>Secutron</strong> - Shortcut to start the new interface.• Choose Edit/Admin Passwords. For convenience, these should probably be set to the same as the rest of theprogram (3 by default), though different passwords can be used if so desired.• Select File/Open from the menu and choose the Modul-R-1.CSI file. Click Open.• Now choose Edit/Communications Settings and select 9600 baud, 8 data bits, parity none and 1 stop bit.Confirm that the channel is 1, enter the Port ID number that you documented during the process described inInstalling and Identifying Ports on page 4 and select OK.• Select Edit/Default CSI and choose Modul-R-1.CSI again.• Now choose File/Save.8
Change language