HomeWorks Technical Reference Guide International Edition - Lutron

Power Boosters and InterfacesPower Boosters and interfaces are required in someapplications to increase the load capacity of acomponent or to interface with a specific type of load.Power Boosters and interfaces can be used withHomeWorks Maestro switches, GRAFIK Eye® controlunits, GRAFIK IntegraleTM control units, Wallbox PowerModules and Remote Power Modules. Power Boostersand interfaces are typically installed in electricalclosets or other hidden locations.F L U O R E S C E N T D I M M I N GB A L L A S T I N T E R F A C E M O D E LN G R X - F D B I - A U ( N O N - C E )Fluorescent Dimming BallastInterfaces are used to dim a singlezone of fluorescent lighting withLutron Hi-lume® dimming ballasts.P O W E R B O O S T E R M O D E L SN G R X - P B - C E A N DN G R X - P B - A U ( N O N - C E )Power Boosters increase the capacityof a single zone of lighting.Compatible load types areincandescent, magnetic low voltage,electronic low voltage (requiresLutron low-voltage transformers), andneon/cold cathode.0 – 1 0 V I N T E R F A C EM O D E L G R X - T V I0-10V interfaces are used to dim asingle zone of fluorescent lightingwith dimming ballasts that require a0-10V signal for control. The TVI canalso be used to switch 10 Amps ofnon-dim electronic ballasts or 1/2HP motors.COMPONENTSE L E C T R O N I C L O W - V O LTA G EI N T E R F A C E M O D E L SN G R X - E L V I - C E A N DN G R X - E L V I - A U ( N O N - C E )Electronic Low-Voltage Interfaces areused to dim a single zone ofelectronic low-voltage lighting. TheELVI is not necessary for use withGRAFIK Integrale or if Lutron lowvoltagetransformers are used (seepage 10.7 of the TRG Rev. E).T E N V O LT M O D U L E SM O D E L T V MTVM modules can be located inHomeWorks® Remote Power Panels.The TVM module is used incombination with the HW-RPM-4Umodule to control fluorescent dimmingballasts that use either a 0-10Vcontrol signal, the DSI control signal,a PWM control signal or the DALIcontrol signal (intensity broadcastonly). For more information consultLutron technical support.S Y N T H E T I C M I N I M U ML O A D I N T E R F A C EL U T - L B X - C E - W HProvides the required minimum loadto a dimmer when the actual load isless than the minimum.D M X - 5 1 2 I N T E R F A C EL U T - D M XLUT-DMX connects to the MI Link(1) of an 8-series processor. Theinterface converts zone dimminglevelsto DMX-512 protocol. Formore information consult Lutrontechnical support.6.2 www.lutron.com