HomeWorks Technical Reference Guide International Edition - Lutron

Module InterfaceModule Interfaces control up to eight RPMs and areavailable in two configurations: either integral to aHomeWorks ® processor or as a stand-alone component.Each HomeWorks 8 series processor can control up to16 Module Interfaces.S TA N D - A L O N E M O D U L E I N T E R F A C E( M O D E L H W I - M I - 2 3 0 )A stand-alone Module Interface controls up to eightRPMs in a Remote Power Panel that does not contain aprocessor. A stand-alone Module Interface installs inHWI-PNL-8-CE, HWI-PNL-5-CE, PBK8-40-13-CE or PBK8-40-13-10-CE.I N T E G R A L M O D U L E I N T E R F A C ESome 8 series processor models (model HWI-PM-230,HWI-PM-H48-230, H8P5-MI-CE and H8P5-MI-H48-CE)contain integral Module Interfaces, allowing up toeight RPMs to be installed in the same panel. Theprocessors with integral Module Interfaces must beinstalled in a HWI-PNL-8-CE Remote Power Panel.View ofstand-alone Module Interface(HWI-MI-230)M A N U A L O V E R R I D E C A PA B I L I T I E SCOMPONENTSA manual override input is provided on each ModuleInterface, allowing a preset lighting scene to beactivated from switches installed anywhere in thehome.C O N N E C T I O N T O P R O C E S S O REach HomeWorks 8 series processor has onecommunication link (Link 1) dedicated to the controlof up to 16 MIs. This connection must be daisychainedand requires two pair [one pair 1.0mm 2 (#18AWG), one pair 1.0-0.5mm 2(#18-22 AWG) twistedshielded] Class 2/PELV wire. Lutron wire model GRX-CBL-346S-500 may be used.Processor with a module interface included5.8 www.lutron.com