2007 Police Interceptor Modifier Guide - Digital Ally, Inc.

2-34 ElectricalSection 2: ElectricalUse the following steps to change this option:• Remove the dash trim panel by gently pulling to release the 9 pushpin-type retainers.• Disconnect luggage compartment lid release switch electrical connector.• Locate and connect the alternate luggage compartment lid release switch electrical connector.Note: The connectors can be identified by the wire colors. The connector with the (VT/YE) and(BK/WH) wires has power at all times. The connector with the (VT/YE) and (YE/GN) wireshas power in the run position.• Reinstall the dash trim panel.Courtesy Lamp Disable (Dark Mode)This option offers deletion of the illuminated entry function. Upon vehicle power-up, the lightingcontrol module (LCM) will not provide interior lighting during entry or exit of the vehicle. Theinterior lighting will, however, still operate on demand whenever the dome lamp switch is active. Ifthe dark car feature is necessary, the assembly plant enables this feature through the LCM. Thevehicle can be reconfigured by entering diagnostics, enabling/disabling the courtesy lamps andthen exiting diagnostics.Use the following steps to enable or disable the courtesy lamps:1. Connect the vehicle communication module (VCM) and integrated diagnostic system (IDS)software with appropriate hardware, or equivalent scan tool to the data link connector (DLC).2. Select the LCM PID ‘‘COURTESY LAMPS’’.3. Select ENABLE or DISABLE.2007 Police Interceptor Modifier Guide, 2006