2007 Police Interceptor Modifier Guide - Digital Ally, Inc.

More documents

Recommendations

Info

Electrical 2-23Section 2: Electrical7. Note: Overlap tubing on both wires.Evenly position heat shrink tubing over wire repair.8. Use a shielded heat gun to heat the repaired area until adhesive flows out of both ends of theheat shrink tubing.2007 Police Interceptor Modifier Guide, 2006
2-24 ElectricalSection 2: Electrical9. Reconnect the battery ground cable.Sealed ConnectorsFord Part Number Part Name ClassE6FZ-14488-A Butt Connector CGauge: 18-22, Color: RedE6FZ-14488-B Butt Connector CGauge: 14-16, Color: BlueE6FZ-14488-C Butt Connector CGauge: 10-12, Color: YellowHeat Shrinkable Tubing (Heat Shrink) (Ford Specification ESB-M99D56-A2)Heat shrinkable tubing is available in various diameters for different splice sizes andconfigurations. When shrunk, it forms a small, flexible hermetic seal.Other methods (tape, PVC mold) do not provide a hermetic seal and are not recommended. Splicebalancing is critical with heat shrink insulation. If the splice is extremely unbalanced (more circuitson one side than the other), heat shrink insulation will not provide a proper seal. Evaluate the useof double terminals instead of splices where practical in these situations.Recommended Splicing Method — Crimp (For 1022 AWG Diameter Wire to Like WireDiameter)1. Disconnect the battery ground cable.2. Strip wires to appropriate length.3. Install heat shrink tubing.2007 Police Interceptor Modifier Guide, 2006
Page 4: General Information 1-1Section 1: G
Page 8 and 9: General Information 1-5Section 1: G
Page 14 and 15: General Information 1-11Section 1:
Page 22 and 23: SECTION 2ElectricalContentsSection
Page 24 and 25: Electrical 2-1Section 2: Electrical
Page 34 and 35: Electrical 2-11Section 2: Electrica
Page 80 and 81: SECTION 3Installation Consideration
Page 82 and 83: 3-2 Installation ConsiderationsSect
Page 90 and 91: 3-10 Installation ConsiderationsSec
Page 92 and 93: Trunk Mounting Considerations 4-1Se
Page 94 and 95: Trunk Mounting Considerations 4-3Se
Page 96 and 97:
Trunk Mounting Considerations 4-5Se
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Trunk Mounting Considerations 4-11S
Page 104 and 105:
Reference Information 5-1Section 5:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Reference Information 5-11Section 5
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126:
show all

2007 Police Interceptor Modifier Guide - Digital Ally, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?