2007 Police Interceptor Modifier Guide - Digital Ally, Inc.

More documents

Recommendations

Info

Electrical 2-5Section 2: ElectricalPowertrain Control Module — Red AreaCAUTION: DO NOT make electrical connections to vehicle electrical systems notspecifically designed for police equipment installations.Do not install any components into the PCM or PCM harness. Connecting into this system mayaffect engine and transmission operation. As an example: connection of aftermarket electricalequipment into the brake light circuit or any other circuit which is connected to the PCM, anti-lockbrake computer, air bag system or any other vehicle system will cause vehicle malfunction.Headlight and Tail Light ModificationsCAUTION: To prevent current spike damage to the lighting control module (LCM), anyauxiliary warning lights controlled by the LCM need diode protection.Headlight Flashers (Wig-wags)Note:If the high beam lights are selected and the wig-wag module is turned on, the high beamlights will turn OFF and the low beam lights are turned ON.2007 Police Interceptor Modifier Guide, 2006
2-6 ElectricalSection 2: ElectricalStandard Feature — An interfacing connector is provided on the headlight circuit for use of theheadlights as alternating flashers (wig-wags). The connector is located at the front side of theradiator. There is a connector cap attached that prevents contaminants from entering theconnector when a wig-wag module is not installed. When installing a headlight flasher (wig-wag)module, remove the connector cap and tape it to the wig-wag module harness. This will make surethat the connector cap is available to be reattached if the wig-wag module is removed. Refer tothe Crown Victoria Wiring Diagram Manual.ItemDescription1 Horns2 Headlight flasher (wig-wag)module connector2007 Police Interceptor Modifier Guide, 2006
Page 4: General Information 1-1Section 1: G
Page 8 and 9: General Information 1-5Section 1: G
Page 14 and 15: General Information 1-11Section 1:
Page 22 and 23: SECTION 2ElectricalContentsSection
Page 24 and 25: Electrical 2-1Section 2: Electrical
Page 34 and 35: Electrical 2-11Section 2: Electrica
Page 78 and 79:
Electrical 2-55Section 2: Electrica
Page 80 and 81:
SECTION 3Installation Consideration
Page 82 and 83:
3-2 Installation ConsiderationsSect
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
3-10 Installation ConsiderationsSec
Page 92 and 93:
Trunk Mounting Considerations 4-1Se
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Trunk Mounting Considerations 4-11S
Page 104 and 105:
Reference Information 5-1Section 5:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Reference Information 5-11Section 5
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126:
show all

2007 Police Interceptor Modifier Guide - Digital Ally, Inc.

Create successful ePaper yourself

Delete template?

Save as template?