Service A-320 1st Stage.pdf - Apollo Sports

More documents

Recommendations

Info

ASSEMBLYInstall the the piston with adjusting screw.Place the piston height gauge on top ofthe lock nut and piston. Ensure that theclearance gap between the surface of thepiston and the surface of the lock nut hasa minimum 0.05mm to maximum 0.1mm. Ifthe piston height is incorrect, adjust theheight by turning the screw until theclearance gap is correctReplace the outer diaphragm and holderusing the Apollo adjusting wrenchTL00005. The intermediate line pressureshould not have moved.A -320
ASSEMBLYThe first stage DIN or Yolk are now ready for use.A final check for leakage should be carriedout after the installation of the 2nd stageand any accessories. (BC hose etc.)A -320
Page 1 and 2: Technical ManualA-320 Balanced 1st
Page 3 and 4: Haapalainen Aarne Johannes s. 6.1.1
Page 5 and 6: DISASSEMBLYRemove the DIN fittingfr
Page 7 and 8: DISASSEMBLYHold the 1 st stage in a
Page 9 and 10: DISASSEMBLYPlace a low pressure air
Page 11 and 12: DISASSEMBLYPlace the HP module on a
Page 13 and 14: INSPECTION & CLEANINGCheck the HP s
Page 15 and 16: INSPECTION & CLEANINGA quick check
Page 17 and 18: ASSEMBLYHp Module AssemblyApart fro
Page 19 and 20: ASSEMBLYSit the retaining ring on t
Page 21 and 22: ASSEMBLYLightly lubricate the o rin
Page 23 and 24: ASSEMBLYUse your nylon drift (or yo
Page 25 and 26: ASSEMBLYReplace the adjusting screw
Page 27 and 28: ASSEMBLYAttach the Apollo low press
Page 29: ASSEMBLYUse a 6mm Allen key wrench

Service A-320 1st Stage.pdf - Apollo Sports

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?