Service A-320 1st Stage.pdf - Apollo Sports

More documents

Recommendations

Info

ASSEMBLYThe Apollo test gauge has a bleed screw,this should be slightly open when turningthe air on. Once the system is pressurisedtighten the bleed screw.NOTE: Ensure all the ports areblanked to carry out the adjustments.A -320
ASSEMBLYUse a 6mm Allen key wrench toset the intermediate (low) pressure.Turn clockwise to increase pressure,counter clockwise to decrease thepressure. When decreasing pressureremember to open and close the bleedscrew to obtain the correct pressurereading.Adjust the pressure to 9.8kg/cm+/- 0.5kg/cm. ( 140psi ) Supplypressure should be 100 - 200bar.Purge the valve several timesand check the low pressure isstable.A -320
Page 1 and 2: Technical ManualA-320 Balanced 1st
Page 3 and 4: Haapalainen Aarne Johannes s. 6.1.1
Page 5 and 6: DISASSEMBLYRemove the DIN fittingfr
Page 7 and 8: DISASSEMBLYHold the 1 st stage in a
Page 9 and 10: DISASSEMBLYPlace a low pressure air
Page 11 and 12: DISASSEMBLYPlace the HP module on a
Page 13 and 14: INSPECTION & CLEANINGCheck the HP s
Page 15 and 16: INSPECTION & CLEANINGA quick check
Page 17 and 18: ASSEMBLYHp Module AssemblyApart fro
Page 19 and 20: ASSEMBLYSit the retaining ring on t
Page 21 and 22: ASSEMBLYLightly lubricate the o rin
Page 23 and 24: ASSEMBLYUse your nylon drift (or yo
Page 25 and 26: ASSEMBLYReplace the adjusting screw
Page 27: ASSEMBLYAttach the Apollo low press
Page 31: ASSEMBLYThe first stage DIN or Yolk

Service A-320 1st Stage.pdf - Apollo Sports

Create successful ePaper yourself

Delete template?

Save as template?