Service A-320 1st Stage.pdf - Apollo Sports

More documents

Recommendations

Info

ASSEMBLYInstall the pushrod assembly.Be sure the pushrod engages the centreof the HP seat. Depress the assemblyseveral times with your thumb to test themovement of the seat assembly.Next install the diaphragm. Bendbetween thumb and forefinger tomake the installation easier. Pushthe diaphragm down to the innershoulder and release.A -<strong>320</strong>
ASSEMBLYUse your nylon drift (or your finger)to push the diaphragm flat all theway around against the inner shoulder.Lubricate the lock nut.The retainer must be tensioned using thebio adjusting TL00008 spanner.Tighten sufficiently to ensure no leakageof air from under the diaphragm, but notso tight as to crush the diaphragm.(Turn clockwise to tighten)A -<strong>320</strong>
Page 1 and 2: Technical ManualA-320 Balanced 1st
Page 3 and 4: Haapalainen Aarne Johannes s. 6.1.1
Page 5 and 6: DISASSEMBLYRemove the DIN fittingfr
Page 7 and 8: DISASSEMBLYHold the 1 st stage in a
Page 9 and 10: DISASSEMBLYPlace a low pressure air
Page 11 and 12: DISASSEMBLYPlace the HP module on a
Page 13 and 14: INSPECTION & CLEANINGCheck the HP s
Page 15 and 16: INSPECTION & CLEANINGA quick check
Page 17 and 18: ASSEMBLYHp Module AssemblyApart fro
Page 19 and 20: ASSEMBLYSit the retaining ring on t
Page 21: ASSEMBLYLightly lubricate the o rin
Page 25 and 26: ASSEMBLYReplace the adjusting screw
Page 27 and 28: ASSEMBLYAttach the Apollo low press
Page 29 and 30: ASSEMBLYUse a 6mm Allen key wrench
Page 31: ASSEMBLYThe first stage DIN or Yolk

Service A-320 1st Stage.pdf - Apollo Sports

Create successful ePaper yourself

Delete template?

Save as template?