Service A-320 1st Stage.pdf - Apollo Sports

More documents

Recommendations

Info

INSPECTION & CLEANINGRubber parts o rings etc. which are going to be re used should bewashed in warm water and detergent.After washing all o rings are to be carefully inspected for damageor distortion.The polyurethane Hp Seat SP90031B is goodfor 3 years. If it is being re installed check itfor any defects.- Deep groove.- Holes.- Delaminating of the polyurethane face.Are all cause for rejection.If you have any doubt on a part REPLACE ITA -320
INSPECTION & CLEANINGA quick check of parts to be reused is carried out prior to cleaning.This will ensure you do not clean obviously defective parts.All metal parts are cleaned using an ultrasonic cleaner. The recommendedCleaning solution is Lawrence Factor Wash. Apollo code TL00040.Only leave the parts in the ultrasonic cleaner until clean, do not leave inthe bath for prolonged periods. Eg; over night.The parts must be rinsed in bicarbonate of soda after removalfrom the ultrasonic cleaner, this helps to neutralise the acid.Rinse with fresh water and then blow dry with clean filtered air.Metal parts must now be carefully inspected prior to refitting.A -320
Page 1 and 2: Technical ManualA-320 Balanced 1st
Page 3 and 4: Haapalainen Aarne Johannes s. 6.1.1
Page 5 and 6: DISASSEMBLYRemove the DIN fittingfr
Page 7 and 8: DISASSEMBLYHold the 1 st stage in a
Page 9 and 10: DISASSEMBLYPlace a low pressure air
Page 11 and 12: DISASSEMBLYPlace the HP module on a
Page 13: INSPECTION & CLEANINGCheck the HP s
Page 17 and 18: ASSEMBLYHp Module AssemblyApart fro
Page 19 and 20: ASSEMBLYSit the retaining ring on t
Page 21 and 22: ASSEMBLYLightly lubricate the o rin
Page 23 and 24: ASSEMBLYUse your nylon drift (or yo
Page 25 and 26: ASSEMBLYReplace the adjusting screw
Page 27 and 28: ASSEMBLYAttach the Apollo low press
Page 29 and 30: ASSEMBLYUse a 6mm Allen key wrench
Page 31: ASSEMBLYThe first stage DIN or Yolk

Service A-320 1st Stage.pdf - Apollo Sports

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?