Cardell MAX-12 HD - Veterinary Instrumentation

CARDELL® MAX-12HD User’s Manualseconds of a continuous pleth waveform being displayed across the screen.When a valid signal is detected, the monitor displays the %SpO2 and PulseRate values. Should the perfusion light be at a low level, reposition the sensoror try a different sensor. If normal operation cannot be achieved, call aMidmark representative for assistance.NOTE: In addition to the V-SAT sensor and clips that are included with themonitor, there is an optional reflectance sensor, the MAXFAST-1, that can beused on the base of the tail. This is mainly used as an alternative whenhead/neck/dental procedures are being performed.9.3 SpO2 SetupTo enter SpO2 Setup menu,Main Menu → Rotate the knob→ SPO2 → Press the knobSee the menu on the right. Enter waveform speed setup. Byrotating the knob and pressing, you can set the sweep speed,the SpO2 alarm limits and pulse rate alarm limits, and turn thealarm on or off.For example, to set the SpO2 waveform speed:Fig. 10-1 SpO2 Setup MenuMain Menu →Rotate the knob→ SPO2 →Press the knob→ Rotate theknob→ Waveform Speed →Press the knob→ 12.5/25.0/50.0mm/S →Rotatethe knob → Press the knobAlarm sound On/OffTo select On/OffOn: To turn on SpO2 alarm sound.Off: To turn off SpO2 alarm sound.To set SpO2 alarm limits,Main Menu →Rotate the knob→ SPO2 → Press the knob→ Rotate theM1.0 5-15-0969