Cardell MAX-12 HD - Veterinary Instrumentation

Cardell® MAX-12HD User’s Manualrechargeable batteries are housed.To load thermal paper: Slightly press the panel of the recorder as thearrow points, then the panel will eject and place paper inside (seerecorder panel diagram for the recorder paper orientation. And pull asection of paper (about 10cm)out and restore the panel.MAX-12HD is Class I device with internal power and complies withIEC60601/EN60601 requirements.Devices connecting to the patient monitor should meet IEC standards.Data processing device should meet IEC950 and medical devicesshould meet IEC60601-1. The complete system should meet the latestvalid standards of IEC60601-1-1.BATTERYBattery Power Supply: 12V 4.6AhWhenever the device is plugged into AC power, the two batteries willautomatically be charged. They should be charged at least for 8 hours beforethey become full. To ensure batteries are fully charged, it is recommended toplug the device in AC power even when the device is not being used.Note: Before the first use, the batteries must be charged.Note: When the device is being stored for a long time, make sure the batteriesare full. Check the battery status at least every month and recharge them.Each fully charged battery can support the device continuously working for1.5 hours, however NIBP measurement and printing may accelerate theconsumption of battery power. When the battery power is almost used up, thebattery mark at the lower right corner of the screen will flash, alerting user toplug the device in AC power as soon as possible. When battery power is notenough to support normal operation of the device, the device will be turnedoff automatically and will not start to work until being turned on after it is20 M1.0 5-15-09