Cardell MAX-12 HD - Veterinary Instrumentation

CARDELL® MAX-12HD User’s ManualWhen necessary, the sensor may be surface-cleaned by wiping it with anagent such as 70% Isopropyl Alcohol.The clip may be cleaned by either wiping it with, or soaking it for ten (10)minutes in, 70% Isopropyl Alcohol. If the clip is soaked, be sure to rinse itwith water and air-dry it prior to use on the next patient.After each cleaning and prior to each use, inspect the sensor and cable forfraying, cracking, breakage, or other damage. Inspect the clip for crackingor breakage, or loss of spring tension that would allow slippage or movementof the sensor from its proper position.NOTE: If defects are noted, do not use the sensor or clip.Refer to the Directions For Use pamphlet enclosed with the sensor for moreinformation.TEMPERATURE PROBESAs necessary, the probes should be cleaned with a mild detergent and water toremove excess bioburden. When necessary, the probes may be disinfectedusing a soft cloth saturated with a 10% (1:10) solution of chlorine bleach intap water or 70% isopropyl alcohol. When all of the surfaces have beendisinfected, wipe the entire surface of the monitor using a soft clothdampened with fresh water to remove any trace amounts of residue and/orfumes.14.2 System CalibrationBesides the routine cleaning of the monitor and accessories outlined in theprevious section, and replacement of accessories due to normal wear and tear,calibration of the monitor should not be necessary during the warranty period.M1.0 5-15-09109