Simulator Configuration Guide for Synopsys Models

Simulator Configuration GuideChapter 3: Using ModelSim Verilog with Synopsys Models3Using ModelSim Verilog withSynopsys ModelsOverviewThis chapter explains how to use SmartModels, FlexModels, DesignWare MemoryModels, and hardware models with MTI Verilog (ModelSim/VLOG.). The proceduresare organized into the following major sections:● “Setting Environment Variables” on page 59● “Using SmartModels with ModelSim Verilog” on page 61● “Using FlexModels with ModelSim Verilog” on page 63● “Using DesignWare Memory Models with ModelSim Verilog” on page 66● “Using Hardware Models with ModelSim Verilog” on page 68Setting Environment VariablesFirst, set the basic environment variables. If you are not using one of the model types,skip that step. In some cases the procedures that follow in this chapter include steps forsetting additional environment variables.1. Set the LMC_HOME environment variable to point to the location of yourSmartModel, FlexModel, or DesignWare Memory Model installation tree, asfollows:% setenv LMC_HOME path_to_models_installation2. Make sure ModelSim Verilog is set up properly in your environment.October 6, 2003 Synopsys, Inc. 59