Simulator Configuration Guide for Synopsys Models

Chapter 7: Using QuickSim II with Synopsys ModelsSimulator Configuration GuideTable 19: Symbol Properties for DesignWare Memory Model ParametersPropertyDefaultDataMemoryFileMessageLevelModelConfigModelAliasModelIdDescriptionSpecifies the data value returned from all uninitializedmemory addresses. On model symbols supplied bySynopsys, the DefaultData value is presented inbinary format.Specifies the file name of a memory image file topreload during model initialization. If MemoryFile isset to either a null string or a single period(MemoryFile = “.”), memory image preloading duringinitialization is disabled.You can use an absolute or a relative path to point to afile. If you use a relative path, it is resolved relative tothe value of $MGC_WD.Represents a 32-bit control word, and controls themodel’s messages. The lowest five bits enable anddisable the following message types:bit 0 — Error messagesbit 1 — Warning messagesbit 2 — Timing messagesbit 3 — X handling messagesbit 4 — Info messageTo enable a message type, set the corresponding bit to1; to disable, set the bit to 0.Represents a 32-bit control word, and used by somemodels to configure aspects of operation (for example,the optional power-on sequence in SDRAM models).Refer to your model’s datasheet for information aboutusing the ModelConfig value with your model.Model-specific identifier for testbench commands inHDL simulators. No effect in QuickSim.Model-specific identifier for testbench commands inHDL simulators. No effect in QuickSim.154 Synopsys, Inc. October 6, 2003