Simulator Configuration Guide for Synopsys Models

Chapter 7: Using QuickSim II with Synopsys ModelsSimulator Configuration GuideTable 13: Symbol Properties used by SWIFT Models (Continued)PropertyPCLFileJEDECFileDescriptionName and path of a compiled PCL file.Name and path of a JEDEC fuse map file.NoteFlexModels use a slightly different set of symbol properties. For informationon the required configuration properties for FlexModels, refer to “UsingFlexModels with SWIFT Simulators” on page 23.You can use either an absolute or relative path name to point to a file. If you use arelative path name it is resolved relative to the value of $MGC_WD.Symbol Properties Required for SimulationTable 14 lists symbol properties that are required for simulation.Table 14: Symbol Properties Required for SimulationPropertyMODELPINPINTYPEDescriptionThe MODEL property contains a label registered astype “SWIFT”.Logic simulation requires that each pin on a symbolhave a property. A PIN property has two valuesassociated with it:● User pin name●Compiled pin nameYou can change the user pin name to adhere todrafting standards, but you must not change thecompiled pin name.Each model pin has an associated PINTYPEproperty, which describes the pin entry point type(i.e., IN, OUT, IXO, or IO). QuickSim II requiresthis property.SWIFT_TEMPLATE The SWIFT_TEMPLATE property always has avalue that specifies the model name. This propertycannot be changed.130 Synopsys, Inc. October 6, 2003