Saunier-Duval-Thema-Classic-F24e-Installation-manual

User Controls and LightingCentral heating temperature selectorminimum setting (approx. 38˚C) up tomaximum setting (approx. 73°C).5Boiler ON indicator(fault indicated bylight flashing red)118802On/Offswitch14Pressure gauge (bar)and temperaturegauge (°C)3Domestic hot water temperature selector (F24E Only)minimum setting approx. 38˚C up to maximum setting 60˚C.6Programmer(F24E Only).The ECO setting is ideally suited for all the requirements of normal family use(showers, washing up etc.). The maximum setting should be reserved for occasional usewhen very hot water is required.1. Lighting the boiler :Make sure that:• The boiler is connected to the electrical supply.• The gas service cock is open.• The room thermostat is calling for heat (if fitted).• Turn the On/Off switch 1 to ON ( I )4. Heating temperature adjustment :• Winter: Set the control knobbetween 1 and 5 (Heating ON)• Summer: Set the control knobto(Heating OFF)2• The boiler ON indicator 52. Stop the boiler :• Turn the On/Off switchelectrical supply is OFF.will illuminate green.to OFF ( 0 ) the3. Domestic hot water adjustment(F24E Only) : 3• Position ( 0 ): Domestic hot waterOFF• Position ( I ) and ECO: Domestichot water between approx. 38˚Cand 50˚C• ECO: Maximum recommendedfor constant use• Between ECO and maxi:Occasional use for water aboveapprox. 50˚C15. If a fault occurs (indicated byred flashing light) : 5• Reset boiler: Turn the On/Off switch to ( 0 ),wait for five seconds. Turn the On/Off switch to (I)the boiler is reset. If the fault continues call yourInstallation/Servicing company or Saunier DuvalService using the telephone number on the insidefront cover of this literature.6. Pressure gauge: 4• The boiler pressure gauge will show a readingbetween 1.0 and 1.5 bar.Refer to Section Draining and Filling if required.Diagram 27 4000124050-2