SurgiGuide Cookbook - Dental-Depot

More documents

Recommendations

Info

Procedure to make a scan prosthesis for a mucosa supported SurgiGuideComplete base plate in 10% Barium Sulfate1. Complete steps 1 through 10 from the procedure for the fabrication of a standardscan prosthesis.2. In step 11, the complete plate should be fabricated with 10% barium sulfate mixture(90g resin/10g barium sulfate) instead of just pure resin. Let this harden under thepress for about 30 minutes.3. Skip steps 12 through 16 and go immediately to step 17.4. Remove the prosthesis from the model and finish it. You can polish the prosthesis toimprove its appearance for the patient.Base plate and teeth with different % Barium Sulfate1. Complete steps 1 through 10 from the procedure for the fabrication of a standardscan prosthesis.2. In step 11, make a mixture of 10% barium sulfate and let it harden under a press forabout 30 minutes.3. Follow the standard procedure for the remaining steps.PROTOCOL38www.SimPlant.comSurgiGuide Cookbook
Scanning Protocol Protocol for SimPlant for SimPlant and SurgiGuide and SurgiGuideThis protocol describes the guidelines for a CT scan that is taken for the purpose of orderinga SimPlant project and/or a SurgiGuide from Materialise. This protocol is preferablytransferred to the radiology department, together with the scan order.SimPlant is the dental planning software of Materialise, which uses high quality CT images forthe preoperative planning of dental implants. The image quality you experience within theSimPlant software depends on the capability of the CT scanner to produce thin-sliced, highresolutionaxial images. It is also essential to the quality of the images, that your scan site isprovided with and properly follows this scanning protocol.With high quality images, the preoperative plan can be made with greater ease and accuracy.At Materialise, SurgiGuide are designed and generated based on both the CT images and thepreoperative plan. SurgiGuide are drill guides that indicate both the position and orientation ofthe planned implants. They are used to transfer the plan to surgery and guide the surgeon’sdrill according to the preoperative plan.Using this scanning protocol as a guideline will not only result in a more accurate plan, but willassure a precise fit of the SurgiGuide on the jaw, and in the end, a pleased patient with nicelypositioned teeth.Preparation of the patientPROTOCOL• Remove any non-fixed metal dentures or prosthesis, in addition to any jewelry that mightinterfere with the region to be scanned. Non-metal dentures may be worn during thescan.• If the patient has a scan prosthesis (a radiopaque copy of the temporary teeth setup), itshould be worn during the scan, as directed by the dentist or surgeon.• Place the patient supine on the scanner table and move the patient into the gantry, headfirst.• Make the patient comfortable and instruct him not to move during the procedure. Normalbreathing is acceptable, but any other movement, such as tilting and turning the headcan cause motion artifacts that compromise the reformatted images, requiring the patientto be rescanned.39www.SimPlant.comSurgiGuide Cookbook
Page 9 and 10: IntroductionIntroductionSurgiGuide
Page 11: OverviewStep 1: DiagnosisIt all sta
Page 15 and 16: DiagnosisStep 1: DiagnosisClear inf
Page 17 and 18: Minimal Invasive SurgeryThe exact p
Page 19 and 20: Step 3: Taking the the 3D scanNo sc
Page 21 and 22: Step 4: Conversion ofStep 4: Conver
Page 24 and 25: Step 6: Ordening SurgiGuide and the
Page 26: 2. Types of SurgiGuide drill guides
Page 29 and 30: SAFE SystemThe SAFE System is used
Page 31 and 32: Step 7: DeliveryStep 7: Delivery an
Page 33: Protocols & SurgicalproceduresSurgi
Page 36 and 37: Procedure to fabricate a standard s
Page 38 and 39: 14. Measure the blended powder and
Page 42 and 43: Aligning the patient• For correct
Page 44 and 45: General scanning instructions• Se
Page 46 and 47: As another example: the remarks fie
Page 48 and 49: After choosing a SurgiGuide type, t
Page 51 and 52: Requirements of a plaster castThe s
Page 53 and 54: Scan prosthesisIf a scan prosthesis
Page 55 and 56: Intact and recent cast in plasterSe
Page 57 and 58: Surgical Procedure: Bone-supported
Page 59 and 60: 2. Positioning of the SurgiGuideCor
Page 61: 4. Subsequent drill(s)Proceed with
Page 64 and 65: Pre-operative actions1. Fit of the
Page 66 and 67: CoolingPrecautions should be taken
Page 69 and 70: Surgical Procedure: Procedure: Toot
Page 71 and 72: Surgical Procedure1. Decision on th
Page 73: 4. Subsequent drill(s)Proceed with
Page 76 and 77: Planning actionsTo achieve full adv
Page 78 and 79: 5. Perform all regular checks for S
Page 80 and 81: 3. Punching/TrephineIf a transmucos
Page 82 and 83: 8. Implant placementScrew the corre
Page 84 and 85: DISLCAIMER OF LIABILITYMaterialise
Page 86 and 87: Preparing the temporary prosthesis1
Page 88 and 89: Implant Surgery and Providing an Im
Page 90:
Contact us:Materialise US - Clinica
show all

SurgiGuide Cookbook - Dental-Depot

Create successful ePaper yourself

Delete template?

Save as template?