Installation Operation Maintenance

InstallationUnit nameplateThe unit nameplate gives thecomplete model reference numbers.The unit power rating is shown, andpower supplies should not deviateby more than 5% from the ratedpower. Compressor motoramperage is shown in box I.MAX.The customer's electricalinstallation must be able towithstand this current.Installation instructionsFoundationsNo special foundations are required,provided the supporting surface isflat and level, and can withstand theweight or the unit.Isolating rubber pads6 pads are supplied as standardwith the machine (55x150mm).They should be placed between thesupporting floor and the unit toisolate from the ground. Trane doesnot recommend to install springisolators.Water drain holeInstall a drain hole wide enough todrain away water from the unit inthe event of shut-down or repair.ClearanceRespect recommended clearancearound the unit to allowmaintenance operation to take placewithout obstruction. For minimumclearance, consult the certifiedsubmittals, which are available onrequest from your Trane Agency.Note for RTCA remote condenser:When determining unit placement,give careful consideration toensuring a sufficient flow of airacross the condenser heat-transfersurface. The unit must be positionedso that the airflow through thecondensing coils is not hindered byany obstacle. The condensing coilsmust be protected from side windswhen their speed exceeds 16 km/h.• Position the unit above theaverage height of snowobserved in the region where itis installed.• Never install temporary orpermanent objects (tarp or roof)over the unit, because recyclingof hot air would reduce thecapacity of the condensing coils.• Discharged air from the fansmust not be obstructed. It isprohibited to install ducts for thefan discharge air (even shortones). This is because the fanssupplied on standard units donot generate any additionalstatic pressure.10CG-SVX06A-E4