LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94BMT T1LM rail dimensionsBasicload ratingWidth Height Pitch Length C C0W1W2WW1KH3M1hφ d2Models SRG25 to 65C/LCStatic permissiblemoment kN-m MA MB MC1 Doubleblock blocks1 Doubleblock blocks1blockLMblockUnit: mmH3 0 W2 M1 F d1d2h Max kN kNkg kg/m-0.054 15 16 15.5 30 4.57.55.3 2500 11.3 25.8 0.21 1.24 0.21 1.24 0.24 0.20 1.584.6 20 21.5 20 30 69.58.5 300021 46.9 0.48 2.74 0.48 2.74 0.58 0.4226.7 63.8 0.88 4.49 0.88 4.49 0.79 0.57 2.584.5 23 23.5 23 30 7119 3000 27.9 57.5 0.641 3.7 0.641 3.7 0.795 0.734.2 75 1.07 5.74 1.07 5.74 1.03 0.93.65 28 31 26 40 91412 3000 39.3 82.5 1.02 6.21 1.02 6.21 1.47 1.248.3 108 1.76 9.73 1.76 9.73 1.92 1.64.46 34 33 30 40 91412 3000 59.1 119 1.66 10.1 1.66 10.1 2.39 1.976 165 3.13 17 3.13 17 3.31 2.46.98 45 37.5 37 52.5 142017 3090 91.9 192 3.49 20 3.49 20 4.98 3.7115 256 6.13 32.2 6.13 32.2 6.64 4.511.610 53 43.5 43 60 162320 3060131 266 5.82 33 5.82 33 8.19 5.9167 366 10.8 57 10.8 57 11.2 7.815.811.5 63 53.5 54 75 182622 3000 278 599 22.7 120 22.7 120 22.1 16.4 23.7Note) The greasing hole on the top face and the pilot hole of the side nipple are not drilled through in order to prevent foreignmaterial from entering the block.See B1-270 for details.The maximum length under “Length ” indicates the standard maximum length of an LM rail. (See B1-224.)Static permissible moment : 1 block: static permissible moment value with 1 LM blockDouble blocks: static permissible moment value with 2 blocks in close contact.6-Sφ H throughφ d1FNEC2CLL1e04-φ D0f0MassLMrailLM GuideIndustrial TechnologiesDescription of Each OptionA1-333DimensionsB1-235B1-219