LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Model number codingTable3 Dimension of the Jointed RailFig.2 Examle of model No.Unit: mmDimension of the jointed railModel No. Height PitchMountingTaperWidth Taper lengthholedepthRadiusM1 F d1d2h W1 W0 a b R14.780.22 15015A 15 60 4.57.55.3 15 14.89 28 0.11 30014.92 0.08 40022.830.17 50025A 22 60 7119 23 22.89 42 0.11 75022.92 0.08 100033.770.23 60035A 29 80 91412 3433.83 0.17 8005433.86 0.14 100033.9 0.1 130044.710.29 80045A 38 105 142017 4544.77 0.23 10007644.81 0.19 120044.86 0.14 160062.480.52 100062.66 0.34 150065A 53 150 182622 63 62.74 107 0.26 200062.8 0.2 250062.83 0.17 3000Model numberNo. of LM blocksper railContaminationprotectionaccessorysymbol (*1)606060Overall linearLM rail lengthper railRadial clearancesymbolNormal (No symbol)Light preload (C1)500Center angleof one innercurved railSymbol forlinear LM railjoint(*1) See contamination protection accessory on A1-352. (*2) See A1-35.Note) This model number indicates that an LM block and an LM rail constitute one set (i.e., the required number of sets when2 rails are used is 2).Model HMG does not have a seal as standard. For the model number above, Fig.2 applies.R 150No. of innercurved LM railsjointedRadius of innercurved railR 300When 2 rails are usedHMG15A 2 UU C1 +1000L T + 60/150R 6T + 60/300R 6T -Radius of outercurved railCenter angle ofone outer curvedrailSymbol forNo. of rails (*2)No. of outer curvedLM rails jointedLM GuideIndustrial TechnologiesB1-185