LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Models RSR-M, RSR-N and RSR-TNLM1.6 through2-×lL1MMModel No.RSR 3MRSR 3NRSR 5MRSR 5NRSR 5TNW2W2W1W1Note) Since stainless steel is used in the LM block, LM rail and balls, these models are highly resistant to corrosion and environment.Models RSR3M and 3N do not have an oil hole. When lubricating them, apply a lubricant directly to the LM rail raceways.No contamination protection seal for RSR3M/3N.To secure the LM rail of models RSR5M and 5N, use cross-recessed head screws for precision equipment (No. 0 panhead screw, class 1) M2.Model number codingOuterdimensionsHeight Width LengthLM block dimensionsGreasingholeGreasenippleM W L B C Sl L1 T K N E d H34 86 12KK1216H3H316.920.120.1— 3.55.58—8M1.6 through—7—Model RSR3MModel RSR3NM1.61.3M21.3M21.5M2.61.8M21.5(*1) See contamination protection accessory on A1-352. (*2) See A1-90. (*3) See A1-101. (*4) See A1-35.Note) This model number indicates that a single-rail unit constitutes one set. (i.e., required number of sets when 2 rails areused in parallel is 2 at a minimum.)2-×l6.710.78.812122 RSR5 M UU C1 +130L P M -Model numberNo. of LM blocksused on the same railContaminationprotectionaccessorysymbol (*1)M1M1LM rail length(in mm)Radial clearance symbol (*2)Normal (No symbol)Light preload (C1)LL1— 3 — — — — 1— 4.5 0.8 — 0.8 — 1.5StainlesssteelLM railSymbol forNo. of rails usedon the same plane (*4)Accuracy symbol (*3)Normal grade (No Symbol)/High accuracy grade (H)Precision grade (P)Industrial TechnologiesB1-120