LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Models NR-A and NR-LAMT1TModel No.NR 25XANR 25XLANR 30ANR 30LANR 35ANR 35LANR 45ANR 45LANR 55ANR 55LANR 65ANR 65LANR 75ANR 75LANR 85ANR 85LANR 100ANR 100LAModel number codingB1-104W2WBW1OuterdimensionsHeight Width LengthLM block dimensionsGreasenippleM W L B C Sl L1 T T1 K N f0 E e0 D0 H331 72 82.810238 9098120.544 100 109.513552 120 13917163 140 162.820062.459 45 M816 14.8 16 25.5 7 7 12 4 3.9 B-M6F 5.581.670.972 52 M1018 16.8 18 31 7 7 12 5 3.9 B-M6F 793.477.982 62 M1020 18.8 20 35 8 8 12 6 5.2 B-M6F 9103.4100 80 M122210513720.5 22 40.5 10 8 16 7 5.2 B-PT1/8 11.5123.6116 95 M1424 22.5 24 49 11 10 16 8 5.2 B-PT1/8 14160.875 170 185.6143.6142 110 M1628245.6 203.683 195 218274KH3M1165 130 M1830170.2226.290 215 246.7194.9185 140 M2034302.8 251105 260 286.2 150223.4220 M2038326.2 200 263.4hφ d2Model NR-A26 28 60 16 15 16 9 8.2 B-PT1/8 1528 30 68 18 17 16 9 8.2 B-PT1/8 1532 34 73 20 20 16 10 8.2 B-PT1/8 1735 38 85 23 23 10 12 8.2 B-PT1/4 20(*1) See contamination protection accessory on A1-352 (*2) See A1-89. (*3) See A1-95.(*4) Specify the plate cover or the steel tape. (*5) See A1-35.Note) This model number indicates that a single-rail unit constitutes one set. (i.e., required number of sets when 2 rails areused in parallel is 2 at a minimum.)Those models equipped with QZ Lubricator cannot have a grease nipple.φ d1NFE 4-SNR35 A 2 QZ KKHH C0 +1400L P T Z -ModelnumberType ofLM blockWith QZLubricatorNo. of LM blocksused on the same railContaminationprotectionaccessorysymbol (*1)LM rail length(in mm)Radial clearance symbol (*2)Normal (No symbol)Light preload (C1)Medium preload (C0)Symbol forLM railjointed useLL1CWith plate cover orsteel tape (*4)e04-φ D0f0Symbol forNo. of rails usedon the sameplane (*5)Accuracy symbol (*3)Normal grade (No Symbol)/High accuracy grade (H)Precision grade (P)/Super precision grade (SP)Ultra precision grade (UP)Industrial Technologies