LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Models SRS-WM and SRS-WN4-SlWB4-SlWBMTModel No.Note) Since stainless steel is used in the LM block, LM rail and balls, these models are highly resistant to corrosion and environment.Model number codingOuter dimensionsHeight Width LengthLM block dimensionsM W L B C Sl L1 T K N H3SRS 7WM 9 25 31 19 10 M32.8 20.4 3.8 7.2 1.8 1.8SRS 9WMSRS 9WNSRS 12WMSRS 12WNSRS 15WMSRS 15WNW2NW112 3014 4016 603950.744.559.555.574.5KModels SRS7WM/9, 12WM/WN21232845122415282035M32.8M33.5M44.52738.730.945.938.957.92 SRS15WM QZ UU C1 +550L P M -ModelnumberNo. of LM blocksused on the same railWith QZLubricatorH3Contaminationprotectionaccessorysymbol (*1)Models SRS15WM/WN4.9 9.1 2.3 2.95.7 11 3 36.5 13.3 3 2.7(*1) See contamination protection accessory on A1-352. (*2) See A1-89. (*3) See A1-101. (*4) See A1-35.Note) This model number indicates that a single-rail unit constitutes one set. (i.e., required number of sets when 2 rails areused in parallel is 2 at a minimum.)Those models equipped with QZ Lubricator cannot have a grease nipple.MTLM rail length(in mm)Radial clearance symbol (*2)Normal (No symbol)Light preload (C1)W2StainlesssteelLM railNW3W1Symbol forNo. of rails usedon the same plane (*4)KH3Accuracy symbol (*3)Normal grade (No Symbol)/High accuracy grade (H)Precision grade (P)Industrial TechnologiesB1-54