LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Models SNR-CH (Build to Order)and SNR-LCH (Build to Order)4-S(φ H through)WBModel No.SNR 35CHSNR 35LCHSNR 45CHSNR 45LCHSNR 55CHSNR 55LCHModel number codingMOuterdimensionsHeight Width LengthLM block dimensionsGreasenippleM W L B C S H L1 t T T1 K N f0 E e0 D0 H348 100 109.5135tTT1W282 62 M10 8.579104.560 120 138.2105100 80 M12 10.5171 137.870 140 163.3123.6116 95 M14 12.5200.5 160.8K20 18.8 16 39 12 12 12 6 5.2 B-M6F 922 20.5 20 48.4 18 16 16 8.5 5.2 B-PT1/8 11.624 22.5 22 56 18 17 16 10 5.2 B-PT1/8 14SNR45 LCH 2 QZ KK C0 +1000L P T Z -ModelnumberType ofLM blockWith QZLubricatorNo. of LM blocksused on the samerailContaminationprotectionaccessorysymbol (*1)(*1) See contamination protection accessory on A1-352 (*2) See A1-89. (*3) See A1-95.(*4) Specify the plate cover or the steel tape. (*5) See A1-35.Note) This model number indicates that a single-rail unit constitutes one set. (i.e., required number of sets when 2 rails areused in parallel is 2 at a minimum.)Those models equipped with QZ Lubricator cannot have a grease nipple.W1LM rail length(in mm)Radial clearance symbol (*2)Normal (No symbol)Light preload (C1)Medium preload (C0)Symbol forLM railjointed useH3With plate coveror steel tape (*4)Symbol forNo. of rails usedon the sameplane (*5)Accuracy symbol (*3)Normal grade (No Symbol)/High accuracy grade (H)Precision grade (P)/Super precision grade (SP)Ultra precision grade (UP)Industrial TechnologiesB1-38