LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Models SNR-C and SNR-LCMtTModel No.SNR 25CSNR 25LCSNR 30CSNR 30LCSNR 35CSNR 35LCSNR 45CSNR 45LCSNR 55CSNR 55LCSNR 65CSNR 65LCModel number codingB1-30T1W2WBW1OuterdimensionsHeight Width LengthLM block dimensionsGreasenippleM W L B C S H L1 t T T1 K N f0 E e0 D0 H331 72 82.810238 90 98120.544 100 109.5135KH3M162.459 45 M8 6.8 16 14.8 12 25.5 7 6 12 4 3.9 B-M6F 5.581.672.172 52 M10 8.5 18 16.8 14 31 7 7 12 6.5 3.9 B-M6F 794.682 62 M10 8.579104.552 120 138.2105100 80 M12 10.5171 137.863 140 163.3123.6116 95 M14 12.5200.5 160.875 170 186143.6142 110 M16 14.5246 203.6hE(φ H through)Model SNR-C20 18.8 16 35 8 8 12 6 5.2 B-M6F 922 20.5 20 40.4 10 8 16 8.5 5.2 B-PT1/8 11.624 22.5 22 49 11 10 16 10 5.2 B-PT1/8 1428 26 25 60 16 15 16 8.7 8.2 B-PT1/8 15SNR 85LC 90 215 302.8 185 140 M20 17.6 251 34 32 28 73 20 20 16 10 8.2 B-PT1/8 17SNR45 LC 2 QZ KKHH C0 +1200L P T Z -ModelnumberType ofLM blockWith QZLubricatorNo. of LM blocksused on the same railContaminationprotectionaccessorysymbol (*1)φ d2(*1) See contamination protection accessory on A1-352 (*2) See A1-89. (*3) See A1-95.(*4) Specify the plate cover or the steel tape. (*5) See A1-35.Note) This model number indicates that a single-rail unit constitutes one set. (i.e., required number of sets when 2 rails areused in parallel is 2 at a minimum.)Those models equipped with QZ Lubricator cannot have a grease nipple.φ d1NFLM rail length(in mm)Radial clearance symbol (*2)Normal (No symbol)Light preload (C1)Medium preload (C0)4-SLL1CSymbol forLM railjointed usee04-φ D0f0Symbol forNo. of rails usedon the sameplane (*5)With plate coveror steel tape (*4)Accuracy symbol (*3)Normal grade (No Symbol)/High accuracy grade (H)Precision grade (P)/Super precision grade (SP)Ultra precision grade (UP)Industrial Technologies