LM Guide THK - Industrial Technologies

Индастриал Технолоджис www.industrial‐technologies.com.ua +38 044 498 21 94Models SHS-C and SHS-LC4-S(φ H through)WBModel number codingB1-6Model No.SHS 15CSHS 15LCSHS 20CSHS 20LCSHS 25CSHS 25LCSHS 30CSHS 30LCSHS 35CSHS 35LCSHS 45CSHS 45LCSHS 55CSHS 55LCSHS 65CSHS 65LCMOuter dimensionsHeight Width LengthLM block dimensionsGreasenipplePilot hole forside nipple M W L B C S H L1 T T1 K N E e0 f0 D024 4764.479.430 63799836 709210942 9010613148 10012215260 12014017470 14017121390 170221272T1TW24838 30 M5 4.4635.9 8 21 5.5 5.5 PB1021B 4 4 353 40 M6 5.4 59787.2 10 25.4 6.5 12 B-M6F 4.3 5.3 357 45 M8 6.8 71889.1 12 30.2 7.5 12 B-M6F 4.5 5.5 372 52 M10 8.5 80 11.510515 35 8 12 B-M6F 5.8 6 5.282 62 M10 8.5 93 11.512315 40.5 8 12 B-M6F 6.5 5.5 5.2106100 80 M12 10.5 14.1 18 51.1 10.5 16 B-PT1/8 8 8 5.2140116 95 M14 12.513117316 21 57.3 11 16 B-PT1/8 10 8 5.2175142 110 M16 14.5 18.8 24 71 19 16 B-PT1/8 10 12 5.2226(*1) See contamination protection accessory on A1-352. (*2) See A1-89. (*3) See A1-95. (*4) See A1-35.Note) This model number indicates that a single-rail unit constitutes one set. (i.e., required number of sets when 2 rails areused in parallel is 2 at a minimum.)Those models equipped with QZ Lubricator cannot have a grease nipple.W1KSHS25 LC 2 QZ KKHH C0 +1200L P T Z -ModelnumberType ofLM blockWith QZLubricatorNo. of LM blocksused on the same railContaminationprotectionaccessorysymbol (*1)LM rail length(in mm)Radial clearance symbol (*2)Normal (No symbol)Light preload (C1)Medium preload (C0)H3With steeltapeSymbol for LM railjointed useSymbol forNo. of rails usedon the sameplane (*4)Accuracy symbol (*3)Normal grade (No Symbol)/High accuracy grade (H)Precision grade (P)/Super precision grade (SP)Ultra precision grade (UP)Industrial Technologies